0
if you are talking about the hole in the bottom of some of the handles those are to hold an extra dart
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Does the Nerf longstrike cs-6 have a hole in the handle to hold a dart?
No.
What is the hole under the handle on the raider cs-35?
Assuming you are talking about the handle near where the trigger is situated, the hole on the underside is for storing on spare dart which can be removed and used whenever you need it. I don't personally use it much; It's just one shot, and it can fall out, however it is useful for adding it into an unfilled 'Nerf n-strike clip system' dart clip.
How do you put together a Nerf raider drum?
There is the orange piece that comes with the blaster that you will need in order to work this blaster's drum. It is attached to the hole in the side, and is attached. The drum may now be inserted.
What is hole on reload clip for on Nerf deploy?
its either for a jamming check or so you can aim
What is the hole on the bottom of the Nerf cs-35 and cs-6?
to store an extra dart
Can Nerf guns shoot real bullets?
No. Nerf darts have a hole in the back which is inserted or loaded onto a post inside the chamber or barrel which keeps them in place. Bullets do not have that hole and would not fit into any Nerf gun. And even then, Nerf guns rely on springs and air for power. Real bullets are fired using an internal hammer which strikes the back and sets off a chain reaction inside the bullet, which releases it.
How is the Raider Nation different from other football fans?
The Raider Nation is different from other football fans because they are known for attending games in elaborate costumes and they are associated with a section of the Oakland Coliseum known as the "black hole".
How do you handle your boyfriend when he changes on?
you slap him in his face and call him an a**hole
Can you put a scope on a tippmann bravo one gun?
Not unless you get the handle adapter and drill a hole in the carry handle.
How can you fix a key hole that has been removed and left a hole in the door?
# Replace the door. # Patch the door. # Install a hole cover. # Install a closet handle.
How big a hole is needed for a shower valve?
Typically a hole for a single handle shower valve can be easily created by a good 3 5/8" hole saw. If u are installing a 2 or 3 handle valve the hole is 1 1/8inch hole saw. Take care in using the hole saw. Please read all manufacturer directions before u install this valve.
How do you replace 1994 Chevy cavalier door handle?
Through the hole that the door handle comes through you can feel a screw. Remove the screw and the handle should come off.
