answersLogoWhite

0

the slotted plug is removed when you need to turn the crank over by hand, such as to adjust valves,or to perform leak down test. You would find a nut inside as to use a socket on,for rotating the crankshaft

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What are the two holes with slotted plugs in a Honda 300 EX for?

These two holes are called inspection holes. The larger one is there so that it is easy to turn the engine by hand in order to adjust the camshaft valves. There is a large nut inside which you can put a socket head on in order to turn or crank the engine crankshaft over. The smaller hole will give access to the T (time) mark on the engine's flywheel.


Where is the firewall hole located on a 1999 Honda Prelude?

under the fuse box on the passenger side of the engine compartment, near the windsheild.


Which hole does the rubber stopper go in inside the carb of 1986 Honda fourtrax fourwheeler?

Just sso happens I tore into my carb today and the rubber stopper goes 2nd hole.... outside in .....towards the main jet


Where are the timing marks located on 1.9 engine?

Since we don't know what car the engine's in, and many manufacturers made an engine this size, we can only go by this: If the car is ANYTHING but a Honda, there's generally a line on the crankshaft pulley and another on the engine block. If it's a Honda, the line is on the flywheel and there's a hole in the bellhousing to see it through.


Where is the oil dipstick on a 1997 Honda CR-V?

On the center-front of the engine is a metal shroud with a hole in the middle of it. Look down through this hole and you should see the dipstick. (not the most user-friendly design)


When was The Hole - album - created?

The Hole - album - was created in 1986-05.


Where is the 1988 Honda goldwing engine oil drain plug located?

The oil drain plug is located on the underside of the engine directly below the filler hole. The head of the bolt will need a 17mm socket to remove.


How do you remove butt stockof 12 GA diamond arms shotgun?

Remove the butt plate. There will be a hole. There should be a slotted screw at the bottom of the hole. Use a long screwdriver and be careful to not damage the stock.


How dangerous is it to drive with a hole in your engine?

you cant drive your car if you have hole in your engine because your engine is a propeller for your car.


Where is the dipstick on a 1997 Honda Civic dx?

On the very front of the engine you will see a hole in the center of the exhaust manifold shield. There should be a dipstick sticking up throughout that hole with a orange handle on it. It it is not there it has been lost. You will need to buy a new one.


What are the release dates for Centurions - 1986 Hole in the Ocean Part 1 1-56?

Centurions - 1986 Hole in the Ocean Part 1 1-56 was released on: USA: 1 December 1986


What are the release dates for Centurions - 1986 Hole in the Ocean Part 2 1-57?

Centurions - 1986 Hole in the Ocean Part 2 1-57 was released on: USA: 2 December 1986