0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between through-hull transducer and transom mount transducer?
A thru-hull transducer is mounting through the hull of the boat. So you would actually take the boat out of the water, drill a hole in the boat approx 2" in diameter(depends on transducer model) and mount the transducer "thru-hull." -- A transom-mount transducer is a transducer bolted to the transom of a boat. Both kinds of transducers need to be submerged in the water for them to work correctly. www.sailboattalk.com I dont know a whole lot about this but I do know you dont drill a hole thru the hull. I have a ranger and from the factory mine was placed inside of the hull under my battery storage no hole needed to be drilled. But on a transom mount you have to drill holes into the transom.
Where is the hull id on a boat?
Always on the Starboard side of the transom on every boat
Where is the hull id on a 1977 bayliner runabout boat?
On the starboard side of the transom
What is the first thing after retreiving a boat onto a trailer?
Drain the transom then rinse the hull with water.
How do you find the manufactor date on a boat?
Looking at the back of the vessel, on the starboard side, upper corner of the transom, you should find the hull ID number. The number will either be scribed into the gelcoat, or stamped into a plate affixed to the transom. Generally, the last two digits in the hull ID will be the year model of the vessel.
Where are Vin numbers on Bayliner boat located?
On my 1995 Bayliner the VIN or Hull number is stamped into the right side of the TRANSOM
How can you look up the serial number of a boat?
The hull ID number on a boat is locatedin the upper right hand corner of the transom. It will be stamped on an affixed plate, or scribed into the hull itself.
How can you look up the serial number on a 1967 Owens boat?
The serial number should be located on the hull or the hull member. It should be located on the transom above the water line. It can also be on a plate.
Where do you find the VIN on an old boat?
Usually on the transom - it might be a thin plate covered by layers of paint. To be more precise, after October, 1972 vessels built in the United States were required to place 12 digit hull identification numbers (sometimes referred to as HIN) on the vessel's hull. The HIN is typically sighted on the starboard side transom of these vessels. These numbers are typically imprinted or engraved into the hull. Foriegn made vessels will typically have a hull manufactuerer number somewhere on the back quarters of the exterior hull or inside the hull. These foriegn vessels are not HIN numbers like you see in the United States but more hull numbers based on how many were produced of that model (such as "hull number 512").
Hull ID location for eldo craft boat?
I have a 1980's Eldocraft aluminum boat and the hull# is engraved on the starboard side of the transom. It was a little difficult to make out due to he shallow dept of each digit. Unless someone has painted or made some repairs, in that case you will have to have a new hull # issued by the state you register it in.
How do you find out what year boat you have?
The last two digits in the hull ID number are usually the year of manufacture. The ID number is usually stamped into the starboard side of the transom, near the top.
Where on boat is the transom located?
The transom is the stern of a boat or ship. On a small boat the outboard engine is clamped to the transom.
