the important is contactor, timer, olr.....
The use of a star delta starter is for motor control only and not resistive heating loads. This type of starter is used to dampen the inrush current by using a lower voltage to start the motor.
mnhjjhjjhnbn
how will you start 3phase inuction motor using star delta stater
By using the star- delta starting methodBy using variable rhoestatsBy using auto transformers
The inrush current is reduced. This is the reason for star delta starters. Motor starts on star and after about 10 to 15 seconds, depending on the load of the motor, it switches to a delta configuration to run.
motor can be control by using variable frequency drive
An SCR chip is commonly used to control the speed of a motor. The speed is controlled using an AC circuit and phase angles.
because at the starting the induction motor drawn a heavy current thats why we use starter to increase the starting resistance of the induction motor!
two contecter <<>> There are three contactors used in a Star Delta configuration.
230/400 V These motors can be connected in star to a mains of 400 V between the phases (see figure 1). figure 1 Star connection 400/695 V These motors should be connected in delta to a mains of 400 V between the phases (see figure 2).
The DC motor speed control has a scope of four speeds. The control speeds include; high, medium, low, and off.
By using your brain