load factor is the ratio of average load to max demand for a given period.
High load factor means
No. It depends on the inductive and capacitive reactance of the load.
The ratio of active power (real power) and apparent power is called power factor ( pf ). Power Factor ( pf ) = Active Power / Apparent Power = .................. ( kvar )
No. In the simple case of a linear circuit, the power factor is the cosine of an angle, and that can't be more than 1.
The greatest factor of a single term is the term itself.
Yes. Power factor is never greater than one, nor less than negative one. It is the cosine of the phase angle, and is the ratio of true versus apparent power.A negative power factor can occur in the case of a generator.
See Related Links
To improve the power factor
A three-phase 'unbalanced' system refers to the load, as the supply voltages are unaffected by load. So the phase-angle and, therefore, the power factor of each phase will be different -i.e. there will be three different power factors.
clock system
It depends on the purpose where you are using the Capacitor.If you are using in power systems then it may be used for improvement of Power factor.Which is the important factor in industry.
It depends on the purpose where you are using the Capacitor.If you are using in power systems then it may be used for improvement of Power factor.Which is the important factor in industry.
improvement of power factor
Ripple factor ripple factor is very important in deciding the efficiency of the rectifier .ripple factor give the total power converted AC input to the DC output. Ideal ripple factor should be zero and power factor 1. Ripple factor of half wave rectifier 1.21 and full wave rectifier is 0.48.
In an AC system power is equal to Voltage x Current x Power factor. Power factor is not constant and depends on the type of the load. Ideal value of the Power factor is 1, where as practically remains less then 1.
I'm not sure I've ever seen an induction motor used to correct power factor; it is usually the induction motors that are causing the poor power factor. "Power factor correction" is usually accomplished by adding capacitors to the system to counteract the inductance of large motors.
The mother board, power supply, and chassis
R. L. Sullivan has written: 'Power system planning' -- subject(s): Electric power systems