Want this question answered?
Usually, when you measure something that requires calibration, that work is generally considered important either monetarily or socially. So, you want to make sure you are sure because things are riding on your measurements. The short answer is so you don't screw up :)
Direct current or DC electric motors work for situations where speed needs to be controlled. DC motors have a stable and continuous current. DC motors were the first and earliest motors used. They were found, however, to not be as good at producing power over long lengths. Electric companies found using DC motors to generate electric did not work because the power was lost as the electric was transmitted. Brush DC motors use rings that conduct the current and form the magnetic drive that powers the rotor. Brushless DC motors use a switch to produce the magnetic drive that powers the rotor. Direct current motors are often found in appliances around the home. Alternating current or AC electric motors are used differently based on what type of AC motor it is. Single phase AC motors are known as general purpose motors. They work well in many different situations. These AC motors work great for systems that are hard to start because they need a lot of power up front. Three phase, also called polyphase, AC motors are usually found in industrial settings. These motors also have high starting power built transmit lower levels of overall power. AC power gets its name from the fact that it alternates in power. The amount of power given off by an AC motor is determined by the amount of power needed to operate the system. garyDC motors are of mainly 3 types.series motors, shunt motors, and compound motors. DC motors are mainly used where high torque is required from less speed (rpm),and a constant rpm can be maintained.Used mainly in : lathe ,drill machines, grinding machines, compressors and so on.Ac machines have less expenses. Used widely because Ac is more popular. They have less torque on slow speeds.Used on cooling fans, water pumps etc.
non- examples of feed in lathe machine?
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
what is lathe machine in short answer
difference between lathe and drill machine doing full on piece of metal
difference between lathe and drill machine doing full on piece of metal
Vertical milling machine is for cutting large pieces. The lathe cutting tool motion is perpendicular to the ground. They are said to Karosl lathe.
lathe machine, power depends on the size and power of electric motor and gearbox lathe.
The lathe machine is an ancient tool, dating back to approximately 1300 BC. It was first developed as a two-person lathe by the Ancient Egyptians.
By hand. You can achieve incredible accuracy by hand, it just takes forever. Also lead screws made on the new lathe will be better than the hand filed one and so on...
lathe machine hour
A lot.
christopher solis