0
is it to expensive
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why would your truck's oil pressure drop when it's at high rpm?
You may be using the wrong grade of oil Problem may be a worn oil pump or worn rod and main brgs.
What is the main problem with using hard water?
The main problem with using hard water is that it contains high levels of minerals such as calcium and magnesium, which can lead to limescale buildup in pipes, appliances, and fixtures. This can reduce the efficiency and lifespan of the equipment and also make cleaning more difficult.
What is the purpose of an oil well?
There are many purposes to using an oil well for any major oil companies. The main reasons to using oil wells however is to bore into the ground to access petroleum oil.
What are the disadvantages of using an oil water separator?
emulsifier. Also, a device that removes oil from water, or water from oil - depending upon its application.
What are the downsides to using cheap oil?
The main downside of using cheap oil is the production of cheaper oil can be a threat to renewable and more environmentally friendly energy sources. This could ultimately be harmful for the environment.
What is the most common problem with jeep grand cheroke limited straight 6?
an oil leak from the rear main and also the oil sending unit.
What happens if the main breaker is connected upside down?
If the main breaker is with out any fluid or oil then technically it is no problem. However the operator may get confused while using it, particularly during an emergency situation, he might actually put on trying to put off, which might lead to serious problems.
What is the problem of using simplistic language online?
If by "simplistic language" one is referring to slang or street language, the main problem with using such language online is that others may not be able to understand what is being said.
what is main problem?
the main problem is a problem that occurs in the middle of the story
What is the main problem?
the main problem is a problem that occurs in the middle of the story
What could be the problem when oil pressure loss while driving 04 Chevy Avalanche?
1. verify that the oil pressure is actually dropping using a calibrated oil pressure gauge. 2. most likely scenario, the oil pressure is not really dropping, the oil pressure sending unit on your vehicle is bad...common Chevy v8 problem
If the oil pressure light comes on in a 2002 toy corolla with good oil level what is the problem?
Low oil pressure is typically caused by worn main and/or rod bearings. If the oil level is up the problem is almost always the bearings. Rod and main crankshaft bearings ride on a thin film of pressurized oil. Once the bearings wear out the gap between the crankshaft and the bearing increases, allowing the pressurized oil to leak out. The pump cannot produce enough volume to keep the pressure up, then the pressure drops and the sensor turns on, indicating that you have a problem. Try switching to a heavier grade oil. That will be thicker oil which does not leak out as fast. Pick an oil with higher viscosity numbers to see if you can get the oil pressure to go a little higher.
