high pressure oil pump
check the oil level in the hpop.
73l
the hpop on a 99 7.3 is on top of motor right in front of fuel filter it should have a tag that tells part #
on the side of the tire it will tell you the max pressure
Pressure Nominal (PN) is a term used to describe the pressure that a PE Pipe is designed to safely withstand.A pipe's PN number describes the nominal pressure in bars that a pipe can support with water at 20oC.The pressure grades available according to European standards arePN 2.5 - max pressure 2.5 barPN 4 - max pressure 4 barPN 6 - max pressure 6 barPN 10 - max pressure 10 barPN 16 - max pressure 16 barTo convert bar into MPa use the formula: (PN(bar)/10) = MPa.
Check your sidewall....usually whatever max pressure is cold. Check your sidewall....usually whatever max pressure is cold.
19 bar max
160psi
yes i did it
Engine oil HIGH pressure from HPOP pump is TOO LOW. Sometimes just an oil change to 15-40 rotella can alleviate problem BUT usuallly the oil plugs push out of the high pressure pump and cause low oil pressure to the injectors or the ICP sensor failed. the injectors must have high pressure oil to open and allow fuel to flow. the 6.0 hpop is in engine valley just under oil filter housing..do not attempt to replace if your not a ford diesel tech..can be very expensive lesson if you're not familiar with this engine.. normal cost for this oil pump repair is about 3,000.00.
CO2 extinguisher have a max test pressure of 20,700 kPa. Max design operating pressure of 18,570 kPa. The min burst pressure of a cylinder must be at least 2.7 times the max operating pressure. So the burst pressure of a CO2 fire extinguisher will be at least 50,139 kPa