R1(config-router)#metric maximum-hops ?
<1-255> Hop count
r1(config-router)#router eigrp 1
r1(config-router)#metric maximum-hops ?
<1-255> Hop count
BTW: the default is 100.
RIP RIPnetworks are limited in size to a maximum of 15 hops between any two networks. A network hop with a hop count of 16 indicates an unreachable network. The other routing protocols do not use the hop count as the metric, EIGRP uses bandwidth and delay for the metric. OSPF and IS-IS use a relative link cost, BGP uses paths, rules, and policies for the metric.
15
It's Hop Count
we would need to redistribute ospf routes into eigrp and vice versa. redistribution will have to be done on an ASBR(autonomus system boundry router) eg: we have an ospf process wid process id 10 running and eigrp with ASN 20 running in our network redistribution on ASBR would be conf t router ospf 10 redistribute eigrp 20 subnets metric 1 and in eigrp conf t router eigrp 20 redistribute ospf metric 1 1 1 1 1 we see i used 5 ones in eigrp process to redistribute opsf into eigrp. thes 1's are metrics for eigrp namely load bandwidth delay reliability
If Beyonce counts as hip hop it would be her but he loves Usher, Elliot Yamin and Justin Timberlake :) I love Justin Bieber:)))
170
IGRP and EIGRP use the same metric calculation, but EIGRP's metric value is multiplied by 256 to give it more granularity in its decision making.
Compared to RIP, EIGRP has a lower administrative distance. Compared to EIGRP, RIP has a higher metric value for the route. Compared to RIP, the EIGRP route has fewer hops. Compared to RIP, EIGRP has a faster update timer.
show ip eigrp neighborsw
autosummarization
autosummarization
Enhanced Interior Gateway Routing Protocol (EIGRP) was once as Cisco Propitiatory routing protocol for Cisco routers. However many routers that are not Cisco now support the use of EIGRP.