0
AC refers to Alternating Current, as opposed to DC which is Direct Current.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What does it mean when check ac light come on a 4300 international?
system failure
What does ac UK mean?
If you mean .ac.uk as shown in a web address, the ac means "academia" - i.e. part of the education system. The web address could belong to a school or university, for example.
What does it mean when your ac stops blowing cold air?
It usually means that your system has developed a leak. Your AC system is charged with freon gas. If a certain amount leaks out, a safety device prevents the AC compressor from starting. Without the compressor, no cold air.
Is a radiator part of the ac system?
No. The ac system uses a condenser and an evaporator.
You turn your heat or ac on and nothing happens what could this mean?
There are a number of reasons you can turn your AC or heat on and nothing will happen. The system may not be hooked up.
What supplies electical pressure in an automotive circuit?
There is only one electrical device in a standard automobile. It is the battery. All of the electrical system uses the same source. The battery is charged by a three phase alternator that is powered from the engine. In the back end of the alternator there is a full wave bridge system that changes the AC to DC. Voltage is the pressure in an automtive circuit.
Recharging ac system on 2005 dodge magnum?
recharging ac system dodge magnum
How to tell if your car has a bad ac compressor?
You have a system performance test done on your AC system.
How can you stop a leak on the low side hook up on ac system?
You mean the schrader valve? That typically has to be replaced.
Where can you find a wiring diagram for a ford F250 ac system?
It is important to have a working AC system in a car. A wiring diagram for an F250 AC system can be found in the cars maintenance manual.
Does the 2007 Dodge Magnum have an aircompressor sensor?
It doors have sensors for the ac system.It doors have sensors for the ac system.
What is the ratio of rms load voltage to mean load voltage?
The mean load voltage, in other words the average voltage, is zero in an ac system.
