0
Many brands of small appliances for kitchens feature hand mixers with a range of 0-490 rpm and 0-620 rpm. Cuisinart and KitchenAId offer hand mixers with a minimum rpm.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you reduce rpm of universal motor for mixer grinder?
You multiply it by 4.47=x
What is a good way to measure a mixer's power and efficiency?
Mixers are usually measured in watts and rpm's. Watts refer to the power, or the mixer's ability to avoid getting "bogged down". RPM's are needed for speed, such as when whipping cream.
What is normal oil pressure specifications for a 2003 GMC Sonoma?
03 GMC Sonoma with the 4.3L Engine: @ 1000 RPM - Minimum of 6 PSI @ 2000 RPM - Minimum of 18 PSI @ 4000 RPM - Minimum of 24 PSI 03 GMC Sonoma with the 2.2L Engine: Minimum of 56 PSI @ 3000 RPM
What is the normal oil pressure on 1993 jeep 4 cylinder?
10psi is minimum. Normal would be 30 at idle, 60 at 3000 rpm.10psi is minimum. Normal would be 30 at idle, 60 at 3000 rpm.
What does a stall convertor do?
a stall will not engage trans until a minimum rpm is reach depending on rpm range of the stall converter
What is the normal oil pressure for a dodge neon?
Normal is 20-30 psi at idle. 40-60 at 3000 rpm. Minimum at idle is 10psiNormal is 20-30 psi at idle. 40-60 at 3000 rpm. Minimum at idle is 10psi
What is the minimum cranking speed of a Magnetron Electronic ignition system?
250 rpm
How much compression should a kawasaki zx6r have?
Minimum is 9,7bar.after that will run poor on low rpm.
What is an RPM dial?
it shows the wheel rotations per minute. multiply the number the the hand is pointing to by one thousand, and that will give you the accurate rpm
How much oil pressure does a 1999 Chevrolet 5.3 silverado have?
Oil pressure (minimum)1000 RPM...........................6 PSI2000 RPM...........................18 PSI4000 RPM............................24 PSIPSI/pounds per squire inchAnything above those reading are fine too.
Concrete mixer whose motor got following configuration 5.5 KW 380v 1140 RPM 3 phase what is the suitable size of generator to run this motor?
You should get a 3 phase generator that has 8-12 KW. If you had to you could use a 3 phase 5.5-6 kw but it may wear out faster because you are using 100% power. The 3 phase gen will allow you to select 480 volt which can be converted to 380 for the mixer. The rpm of the motor in irrelevant because the generator is the power source in this situation, once the gen powers the motor it will produce 1140 to power the mixer.
What is the minimum cranking speed fo engine?
(i) Reciprocating spark ignition engine 60 to 90 rpm.(ii) Rotary spark ignition engine 150 to 180 rpm. (Hi) Diesel engines with glow plugs 60 to 140 rpm. (iv) Diesel engines without glow plugs 100 to 200 rpm.
