It is called a vent window latch.
All you have to do is if its a power window truck is take the screws out of the door panel and pop all the clips loose. Then unplug the window and lock switches. There are 3 bolts that hold the mirror on behind door panel. If manual locks and windows, mainly the same but dont have to unplug wires but have to pop clip off handle for window and lock.
power window and lock fuse for driver side door
Most cars have the key code on the passengers door lock ...
You have to slip a plastic strap used for banding skids,etc. through the window and wrap it around the door lock. Pull it tight and up at the same time. This will unlock the door. Do not pry to hard on the window when you slide the strap down the window to the lock.
It depends whether or not your trailblazer came with heated seats, but if it did the switch would be on the door. The door switches should be (from front to back) Window Lock, Forward Window Controls, Passenger Window Controls, Door Lock, Seat Heaters.
If the locks and rear window hatch on a 1998 Chevy Blazer lock and unlock by themselves, there is probably a problem with the fuse or a short somewhere. The locks are supposed to lock when the vehicle gets put in gear. Perhaps the system that tells the locks when to lock is not working properly.
Ignition Lock? or Door Lock?
The rear window lock on the 2000 Blazer might have gotten rusty and will not turn to unlock the window. Try spraying a lubricant like WD-40 into the door lock. Wait a few minutes and then try the key in the lock.
If the bike has a quill stem, then there is a wedge at the bottom of it to lock the stem into the fork. There are also rare seat posts which use a wedge at the bottom as opposed to the regular seat post clamp. Even rarer are brakes who are activated by a wedge being moved to bring the brake arms together. Old cranks may use a special type of wedge called a cotter to lock the crank to the bottom bracket spindle.
Chevy uses lock washers. ;-)
lock and key wedge systemhieroglyphicspyramids
One way to lock the window in place without using screws is to cut small blocks of wood and place them on top of the window, between the lower window and the upper frame.
Lock Smith / Dealer.. Or a Junk Yard.
You first need to make sure you do not have the window lock activated. It may also be that a fuse has gone out.
You should have a manual with the slim jim, it if very tricky to do, on electrial doors, be careful or u can pull the wires out. go in about 2 inches and should be a rod to pull up some you push, they are all different, did you get a wedge with your Slim Jim? You can roll window down leave it sticking up about an inch and place the wedge in the window spreading the door out a little so you can see inside of the lock.
window lock is on, you may need a motor or a regulator.
Check your window lock switch.
You have to have a window crank remover, this tool looks like a U on a stick, and you slide this tool in between the the crank and the door panel and trip the lock pin, then the crank will pull off.
Replace the lock
The trunk lock on a 1989 Chevrolet Caprice is replaced by removing the retaining clip and unscrewing the bolts holding it in place. The lock can then be pulled through the opening and a new lock put in place.
Buy a can of lock unfreeze or wd-40
The Chevy Equinox was produced from the years 2005 to present in Ontario, Canada. The power lock relay in a 2008 Chevy Equinox is located in the interior fuse box.