answersLogoWhite

0

What else can I help you with?

Related Questions

What is the maximum number of gears on a motor vehicle?

There is no maximum. The manufacture could theoretically put as many gears as they want. Mercedes Benz has a 7 speed transmission & Chrysler has an 8 speed transmission. Long haul semi-trucks have 26 gears ratios or more.


Why does my 95 ford escort take so long to shift between gears it is an automatic transmission?

Your 1995 Ford Escort might take a long time to shift between gears because the transmission fluid is low or very dirty. An automatic transmission requires the correct amount of fluid to operate properly.


Why your Acura TL is taking to long to switch gears?

There is a speed sensor under the left side of the engine, close to the oil filter. When this goes bad, the transmission hesitates to shift upwards because of incorrect speed signal.


Where do you put transmission fluid on 1990 cougar?

You are going to need a long funnel as it goes into where you pull the dipstick for the transmission fluid out


How do you use shift gears in automatic car?

Don't do it, it will only beat the you know what out of your transmission in the long run. If you would like to see metal shavings when you change your transmission fluid and a very expensive bill.......then go right ahead.


Should you change the transmission fluid filter in a 1997 Chevy S-10 Blazer with over 100K miles?

as long as you '''DON'T''' flush it, you should be ok. DO NOT let the shop trick you in to a flush. If the transmission fluid has been low or is very old, the gears inside the transmission are not lubricated as they should be while driving. When the metal gears rub against each other with little or no fluid for lubrication, lots of little metal shavings will be created and end up in the transmission fluid filter. When you get one of those flushes the shops will try to sell you, the transmission fluid is pumped backwards through the transmission filter, then through the gears and then out of the system. This would work fine if your transmission has never been low on transmission fluid or had a clogged transmission filter. But if you have metal shaving in your transmission fluid filter/oil pan. This will be the death of your transmission. Because all the metal shavings are pumped back into the gears, where they will be stuck. Running a transmission with lots of metal shavings inside of it, is not much different from running it with sand in between the gears. So, yeah. Just like the other guy said. If you have an older or abused car, DON't let the shops talk you into getting one of those reverse transmission flushes. This will turn a transmission that's semi-usable into a completely blown transmission I'd say about 25 to 100 miles of driving later down the road.


What is gears?

There are gears in the transmission and a set of gears in the axle(which one depends if it is fwd,rwd or all), the gears multiply the engines torque going to the tires. This allows vehicles to accelerate/tow more, allow for a certain speed/rpm rate. More gears allows for quicker accelerating 1st gear(higher #) and (lower#) top gear for better fuel economy.


1994 Bronco that has an E40D transmission in it Some times it takes a long time to shift from all gears but works well every other time?

try changing fluid and filter (if any)


Is act 3 on gears of war long?

no


Why is your 1993 Pontiac Trans Am taking to long to change gears?

Transmission fluid is low. Check the level of this fluid ONLY with the engine running and at normal operating temperature. To check it otherwise WILL give a false reading. You cannot check the transmission fluid level on a cold and idle engine.


Yes as long as it is automatic transmission.?

Yes as long as it is automatic transmission.


Where does transmission fluid go in a 2002 Mercury Sable?

Check under where the brake fluid goes its hard to get too and you will need a long spouted funnel