should be a sticker on fan shroud
Alternator, idler pulley, Power Steering, a/c, tensioner pulley, crankshaft pulley, water pump this is the order cant upload the picture but when placing the belt on if the pulley has the grooves in it the grooved side of the belt should face the pulley and if the pulley is smooth then the back of the belt faces the pulley
were do i find a diagram for the serpentine belt for a 01 ford expedition
That depends entirely on which engine you have.
You will need to loosen the tensioner pulley. Slide the tensioner pulley to the right and the serpentine belt will become loose. Remove the old serpentine belt and put the new serpentine belt on. Slide the tensioner pulley to the left and tighten it.
about $135 at the dealership
In Short Yes Did it on my own 01 civic Just need to get different belt for the alternator
Yes you can. However, they do not make a specific serpentine belt for bypassing the ac compressor on a 99-01 Hyundai Sonata. You would have to measure the exact length you need to bypass the ac compressor. The belt would then go around the power steering, crankshaft, and alternator. The tension can be adjusted to fit this custom belt as well.
No, it will only match '95 -'01 Taurus. They changed the mounting frame in late '01
Silent Chaos Serpentine was created in 2006-01.
What dose the fuel sending unit look like on a 01 taurus?
singal relay where 2001 Taurus
there is no carb on a 01 taurus. it is all an efi system
Yes they are because the Taurus was redesigned in 2002, so the materials from te '99-'01 Taurus are mostly the same Just make sure you use the heads off of the same engine ie: 1996 Taurus 3.0 OHV will fit a 2005 Taurus 3.0 OHV but will not fit an OHC engine