0
What is the piece called that holds the lampshade on the lamp - a round disc that screws around the thread of the base?
Wiki User
∙ 11y ago
It's called a finial.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Which simple machines are made of other simple machines?
screws have something called a thread, and this thread wraps around the screw. You can call the thread a kind of ramp, because this thread prevents the screw from falling off.
What is wrapped around a screws rod?
The part of a screw that is wrapped around the central shaft of the screw is normally called a thread. It can be described technically as an inclined plane.
What is the name of the wire piece that goes around a light bulb that holds a lampshade?
The flexible wire in a lamp is called the filament. the word means 'thread-like', and it comes from the fact that you need a particularly thin section of wire in order to get the metal to incandesce (glow) at relatively low wattages.
What is the spiral groove around the shaft of a screw called?
Thread
Can you use unc screws in apart that has unf threads?
No. The coarse thread UNC screws will not thread into the fine thread UNF holes. UNC must be used with UNC and UNF with UNF.
What are screw threads?
A screw operates by a raised ledge which proceeds up the shaft of the screw in a spiral. This raised ledge is called the thread of the screw. Since the spiral can either proceed in a clockwise or counterclockwise manner, we distinguish between right-hand thread screws (counterclockwise as viewed from above) and left-hand thread screws (clockwise).
What has a cut going around it that is called a thread?
A screw or a bolt.
How do you stop metal carburetor screws from loosening due to engine vibration?
First , check the screws and the thread bores to make sure they are 1. Correct size and thread ( not metric in a standard thread or vice versa ) 2 the threads are not worn or stretched on the screws . Checking stretch can be done with calipers or even by feeling for the screw to be thinner at some point if the screw is long enough to do so. Most screws are not hardened so it is easy to stretch them or for them to have excessive wear. If you feel that either or both conditions exist replace them. With good screws . If you've inspected everything and all seems fine then apply a SMALL amount of BLUE thread locker to the screws and install them. Do not use Red thread locker. The Red thread locker is too strong and will make disassembly nearly impossible
To use a needle and thread?
To use a needle and thread could be called sewing.To use a needle and thread could be called quilting. To use a needle and thread could be called embroidery. To use a needle and thread could be called suturing.
What is thread holder?
the holder of a thread is called a spool
What is the difference between thread angle and lead angle also clear it from diagram?
A thread angle is the angle of the threads relative to the shank which is 60 degrees for unified screws The lead angle is the pitch of the screw divided by the circumference of the shank; it varies but is around 3 degrees
How many parts are there in a spinning jenny?
There are 14 peaces of wood, 11 strings to pull the thread, 28 screws, and the thread please dont call me a nerd
