0
there is no point to RE unless you are religious i find its just a lesson to pass the time. they had a half hour gap to fill so they chose RE just to fill in.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What does rop stand for at you haul?
re order point
What is the point of view in the story rashoumon?
re[se []ap6
What does rop stand for at U Haul?
Re-Order Point
What was the turning point in Battle of Midway and when did it happen?
When USN dive bombers struck the IJN flattops in the middle of their re-fuelling and re-arming operations.
How can you reuse a ball point pen if it is not used for a long time?
Burn the tip of the ball point for few seconds and try to re-write it.
What happens if a tennis ball hits the score card and goes in during a point?
You Would probably re-play the point and fix the score.
How many points is the letter N worth in scrabble?
The letter N tile is worth one (1) point in standard scrabble. N=1 point. Depending on its position, the 'N' score can be doubled, re-doubled, tripled or re-tripled.
How Snow point but you cant because you need to obite rock climb?
umm can you re word that for me
What is the difference between re-order levels and re-order quantity?
) Reorder Level - Maximum Consumption x Reorder Period Reorder Period = is the amount of time from the point at which you determine the need to order to the point at which the inventory is on hand and available for use But Re Reorder Quantity is - How much quantity to be ordered when stock reached below reorder level - Anurag
Can you re-use wii point cards?
No, because it might be the same thing as the Nintendo Points Card
What is the value of S in scrabble?
S=1 point. Depending on its position, 'S' score can be doubled, re-doubled, tripled or re-tripled and it can also carry the score of the word to which it will be connected.
How do you prove crystals are pure after re crystallisation?
One of the easier and more reliable ways to check if a solid compound is pure after re-crystallization is to check its melting point. Impurities will always lower the melting point of a sample, and the more impure, the lower the melting point will be. By checking the melting point of your sample with a reference value from a book or reliable internet source, it can be determined exactly how impure the sample is. If perhaps your compound is unknown, and thus are unable to obtain a reference value, you could obtain melting point of the sample, and then re-crystallize a few more times, obtaining a new melting point each time, until it is unchanged by re-crystallizing. This will of course decrease your yield, but if there is little fluctuation in your series of melting points, you can be sure you have a relatively pure sample.
