Typing in 192.168.1.1 into a web browser should open the router configuration page. From here, login data specified by the provider will need to be inputted in order to access the configuration page.
Check with the manufacturer but first try 'admin' for both.
it doesn't actually start with a wep key, you need to change this on the bt router configuration page which i am trying to find as well
For some network issues, you'll need to update the settings for your router. Every router has different ways to configure it. However, most manufacturers provide a router configuration web page to edit router settings. You can usually open a router's configuration page by going to that router's IP address on the network. == # On your computer, click Start, Run, type cmd, and press ENTER. A window with a command prompt will appear. # In the window, type ipconfig /all and press ENTER. # Look for a line that starts with "Default Gateway" and write down the address (usually it will be 192.168.1.1 or 192.168.2.1). == Open a web browser, and in the address bar, type http:// followed by the address you wrote down. Press ENTER. The layout of the router configuration page varies by model and manufacturer, but you should be able to browse the pages to find the settings you're looking for. Some settings on your router may be easier to find than others. If you need help finding a particular setting, consult your router documentation or go to the manufacturer's web site for instructions.
The IP address could be anything, since it is assigned as a function of connecting to a network. If the printer is connected to the network, you can find the current IP by printing a configuration page. Check the printer manual for specific procedure to print the configuration page.
You access your router's configuration page. Then, you go to the page that has to do with the forwarding (Gaming,Applications,Security,etc). In there you type the port you will forward, TCP or UDP, and for which IP address.
Is there any computer online using the router. If not then you will need to connect the computer to the router. If yes then you can open the router set up page on that computer. router set up page is the page where you can check all the router settings. Try this web site: fixhomenetwork.com
To disable Protected Mode in a Belkin router, you typically need to access the router's web-based configuration page. Log in with your admin credentials, navigate to the security settings or firewall section, and then disable Protected Mode or adjust the level of security as needed. Be sure to save your changes before exiting the configuration page.
Go into your wireless router settings page
It stands for Maximum Transmission Unit. Not quite sure how to though. All i know is you go to your router's web-based configuration page.
In the router there is a configuration page for port forwarding; set the port you want forwarded to the IP address of the host you want to send packets to.
TFTP trivial file transfer protocol... page 271 of Networking Second Edition Jeffery S. Beasly
The router will have an administration page, normally accessible with a browser, where you can reset the network key. I assume the key is for a wireless network, so you can access the router without a key by hooking up with cable.If you have lost the password for the administration page as well, the router can be reset to default settings with a tiny button somewhere on the box. (The reset button is normally so small that you need a pen or similar to push it.)To find the administration page and the default password, check the router documentation. You can normally find the details on internet when you have the router make and model, or you can contact support department of a computer store.