0
Buttress thread connections are made up to correct "torque" by burying half of the stamped triangle one the Casing pin end. As a rule the torque will vary a few hundred foot pounds either way.
A good habit is to always use this method, but if the client requires a torque figure then and average torque reading over 10 connections can be used as a indicator but this could end up with a previously run connection not sealing due to "run in" deformation and this is highly undesirable. "ALWAYS BURY HALF THE TRIANGLE"
What else can I help you with?
What is the proper makeup torque of 5.5 buttress thread casing?
As always with buttress thread casing, burying half of the triangle (or the 'delta') provides the proper make-up torque.
What is the proper make-up torque of 7 buttress thread casing?
Buttress thread connections are made up to correct "torque" by burying half of the stamped triangle one the Casing pin end. As a rule the torque will vary a few hundred foot pounds either way. A good habit is to always use this method, but if the client requires a torque figure then and average torque reading over 10 connections can be used as a indicator but this could end up with a previously run connection not sealing due to "run in" deformation and this is highly undesirable. "ALWAYS BURY HALF THE TRIANGLE"
What is the Hydril 521 connection make up torque?
Casing Thread ¡ ¡ ¡
What is thread dressing used for on a car?
Used to coat the threads to ensure Proper even torque of bolts or to prevent seizing over time.
What is the correct torque specification for Yamaha outboard motor?
Torque for 50 hp fore stroke casing bolts
What is the recommended torque specification for fastening a bolt into an m4 thread?
The recommended torque specification for fastening a bolt into an M4 thread is typically around 5.9 to 7.8 Newton-meters.
What is 4 inch drill pipe torque up to?
A 4 inch drill pipe torque is used for fishing in small casing.
Is crankshaft pulley bolt reverse thread on a 95 civic 1.6l?
No, the crankshaft pulley bolt on a 1995 Honda Civic with a 1.6L engine is not reverse thread. It is a standard right-hand thread, meaning it tightens clockwise and loosens counterclockwise. Always ensure to use the proper torque specifications when working on the bolt to avoid damage.
What are the flywheel bolt torque specs for a 1967 Pontiac 400?
Torque to 95 foot pounds with thread locking compound.
What is proper lug torque on Pontiac g5?
110 lbs of torque
What thread is the bolt in a Mitsubishi lancer crankshaft?
The thread size for the crankshaft bolt in a Mitsubishi Lancer typically varies depending on the specific model and engine type. Commonly, it is an M12 x 1.25 or M10 x 1.25 thread. However, it's essential to refer to the vehicle's service manual or specifications for the exact thread size for your specific model and year. Always ensure proper torque specifications when installing to avoid damage.
What is the spark plug torque?
Check the service manual for proper torque spec.
