List the 6 steps used by a laser printer to print a page?

Answer 1

1.Cleaning – Excess Toner is Scraped From The Photoelectric Drum. 2.Conditioning – A Uniform -600 Volt Charge is Placed on the Photoelectric Drum By The Primary Corona. 3.Writing – Laser Diodes Write An Invisible Electric Image on the photoelectric drum by causing the Drum surface, to be less negative wherever the laser beam hits. 4.Developing – This is where the transfer roller places the toner on the drum. The toner sticks to the areas that have had the electric charge lessened due to the laser beam 5.Transfer – The Secondary corona uses a positive charge to attract the toner from the drum to the paper. The paper gets charged by corona too. 6.Fusing – The toner is then melted into paper.

Answer 2

Step 1: Cleaning, Step 2: Conditioning Step, 3: Writing, Step 4: Developing, Step 5: Transferring, Step 6: Fusing Step 1: Cleaning, Step 2: Conditioning Step, 3: Writing, Step 4: Developing, Step 5: Transferring, Step 6: Fusing

Answer 3

1. Cleaning. The drum is cleaned of any residual toner and electrical charge. 2. Conditioning. The drum is conditioned to contain a high electrical charge. 3. Writing. A laser beam discharges the high charge down to a lower charge, but only in places where toner should go. 4. Developing. Toner is placed onto the drum where the charge has been reduced. 5. Transferring. A strong electrical charge draws the toner off the drum onto the paper. This is the first step that takes place outside the cartridge. 6. Fusing. Heat and pressure fuse the toner to the paper. 1. Cleaning. The drum is cleaned of any residual toner and electrical charge. 2. Conditioning. The drum is conditioned to contain a high electrical charge. 3. Writing. A laser beam discharges the high charge down to a lower charge, but only in places where toner should go. 4. Developing. Toner is placed onto the drum where the charge has been reduced. 5. Transferring. A strong electrical charge draws the toner off the drum onto the paper. This is the first step that takes place outside the cartridge. 6. Fusing. Heat and pressure fuse the toner to the paper.

Answer 4

Cleaning, Conditioning, Writing, Developing, Transferring, and Fusing. Cleaning, Conditioning, Writing, Developing, Transferring, and Fusing.

Answer 5

1- cleaning 2- conditioning 3-writing 4-developing 5-transferring 6-fusing

Answer 6

Laser printing follows six sequential steps to complete the process. Here are the steps in order: clean, charge, write, develop, transfer, and fuse.