0
What else can I help you with?
Where on a dell printer is the photo conductor?
On a Dell printer, the photoconductor unit is typically located inside the printer, often integrated with the toner cartridge or as a separate component depending on the model. To access it, you usually need to open the front cover and remove the toner cartridge. The photoconductor can usually be identified by its shiny surface and may require periodic replacement to maintain print quality. Always refer to the specific printer's manual for detailed instructions on locating and replacing the photoconductor.
What is the meaning of reset pcu correctly Ricoh Copier?
It means your photoconductor unit is out of whack.If you open the printer, remove your PCU, and reseat it correctly, the error message likely will disappear.
When servicing a laser printer a photoconductor needs to be well removed from what element?
Light source
Which device is not found in the CPU conyrol unit alu registercomputer manager?
the printer
Controls the laser unit in a laser printer?
DC controller
What controls the laser unit in a laser printer?
DC Controller
What can you do with a printer driver?
If a printer is to be dismantled and discarded, the printer driver should be destroyed with a hammer. The driver has a storage unit that stores all the information that the printer has ever printed, providing that there is enough room for storage.
How does a photostat machine works?
I have read it back in my High School that some metals have photoelectric effect, i.e. a charge is generated on them when light falls on them. Selenium, Cadmium are some of the common elements that demonstrate photoelectric effect. Nowadays amorphous silicon being used as a photoconductor in the photocopying machines. When a reflection from the original falls on the photoconductor unit then there is a charge difference in the areas where the document is blank and where it is printed. This makes the photoconductor surface charged unevenly. At this time, the toner which is again a charged colloidal powder (charged opposite to the charge generated on the photoconductor) is applied on the surface and it sticks to the areas where the photoconductor is charged. Thus the image is formed on the photoconductor unit. In order to transfer this image to paper, a transfer charge is applied on the paper which again is of opposite nature than the charge of toner. Thus the charge generated on paper attracts the toner particles and thus the image is transferred to the paper. This paper then goes into the fuser section where the toner is melt by applying heat and pressure and thus fixed. The final product is a photocopy.
What does LSU error mean on a printer?
LSU: Laser Scanning Unit.
What is the function of the output unit?
output unit takes the information from the processing unit and gives us the result. examples are: monitor,speaker,printer etc..
What is the signs that a printer fuser is going bad?
To check for a faulty fuser assembly do the following. Open the clam shell cover of the printer. In the back of the printer is the fuser assembly unit. The green part of this unit on the back portion of the fuser will open.Remember the fuser runs at an extremely high temperature. Be sure you are touching felted portions of the unit only to avoid burns. Gently push the green rear portion of the fuser unit back. Turn the printer around and look through the back. Are there visible streaks or rips in the upper fuser roller? Are there any visible bubbles in the upper fixing roller?If any of these symptoms are present you will need to replace the fuser unit of the printer.
What is the procedure to replace the printer drum for a Brother brand printer?
Make sure the printer is turned on and the drum LED is blinking. Open the front cover. Slowly pull the drum unit and toner cartridge assembly out of the machine. Push down the green lock and take the cartridge out of the drum unit.
