answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the purpose of a primary flow pipe in a hot water installation?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the purpose of a flow meter?

The purpose of a flow meter is to measure the flow of either air or water. They allow one to measure the total volume of air or liquid flow and the rate of the flow.


What is the primary force responsible for the flow of water in a stream?

gravity


What is the purpose of a water valve?

A water valve is used to regulate, direct, and control the flow of water. It can open, close, or partially obstruct passageways where water can travel and flow.


A structure built across a river to control the flow of water?

A dam is built across a river to control the flow of water.


What was the purpose of the canal locks?

To slow down water flow on rapid rivers.


What is the purpose of a Non return valve?

it allows the water to flow in only one direction.


Where should a service valve be located in order to isolate the hot supply from the hot water storage vessel to the taps?

primary flow


What is the purpose of a check dam?

Can be to provide a reservoir of water for industry and domestic use, or to provide water for a hydropower scheme, or to provide water for irrigation.


Why is the water flow in your new bathroom faucet low when you turn on the hot water?

Check the shut-off valve for the hot water side that's under the sink and make sure it's fully open.BECAUSEThe installer did NOT remove the aerator prior to the installation and the flow restrictor is blocked


What is the purpose of a bypass on a water softener?

The bypass on a water softener is a valve that serves the purpose of allowing water from the main point of supply to flow into a house or building when the water softener is being serviced. It can also be used to allow some 'hard' water to be mixed with the softened water.


Where should a service valve be located in order to isolate the hot supply from the water storage vessel to the taps?

primary flow


What is tHe purpose of inlet guide vanes in gas turbine?

In axial flow compressors, the primary purpose of IGVs (fixed or variable) is to guide the airflow onto the first stage rotor blades at an appropriate or required angle of attack.