0
What else can I help you with?
What is bump clearance?
It is the space between the top of the piston and the bottom of the cylinder head. Great care should be used when putting an engine back together to make sure the bump clearance is not 0 so that the piston will not hit the head cylinder.
A technician is performing a cylinder leakage test on an engine The technician sees air bubbles in the radiator with the cap off Which one is the most likely cause?
cracked cylinder head
What is the purpose of a VoIP gateway?
for a good purpose
What is special purpose machinery?
Special Purpose Machinery
What is general purpose resistor?
General purpose resistor is used to resist the current flow.the common resister is general purpose resister.
What is the purpose of a cylinder head on a diesel engine?
The purpose of the cylinder head is Luke Cooper
What is the purpose of using a cylinder head locating pin?
To align the head and the head gasket perfectly to the block.
What is a purpose of a cylinder head?
To produce seaman from the erected function of stuff
What is the purpose of a cylinder head?
To produce seaman from the erected function of stuff
What is the purpose of an exhaust manifold?
The purpose of the exhaust manifold is to connect the exhaust ports on the cylinder head to the exhaust pipe.
What is the purpose of the an inlet valve?
it opens and lets the fuel and air mixture into the cylinder head INLET VALVES
What is the cylinder head casting numbers?
This number will tell you what year and what moter the heads will fit.There are books put out for this purpose.
What is the main purpose of an inlet valve?
it opens and lets the fuel and air mixture into the cylinder head INLET VALVES
Is there a difference between a cylinder head a head cylinder?
No
The cylinder head is where?
The cylinder head is located on top of the engine. The spark plugs thread into the cylinder head(s).....
What is the purpose of the pushrod?
The pushrod is actuated by the camshaft for the purpose of actuating the lifters/rocker arms which, in turn, pushes open either an intake or exhaust valve in the cylinder head.
If you have a crack cylinder head can you have your cylinder head be refaced?
Cracks can be welded and then the head can be resurfaced.
