Because , ic can provide :-
1. very high gain
2. compact & less bulky circuit
1.CE amplifier circuit 2.LC oscillator circuit
A: actually any active components will oscillate with positive feedback A transistor can be used as an amplifier along with an LC tank circuit to form an oscillator; it is an active device (as LIBURNO states) which will amplify the feedback signal coming out of the LC tank circuit. The tank circuit has a natural resonant frequency, meaning the L and C together will try to generate a specific frequency; this is then fed back into the input of the transistor amplifier, and the output is fed to the LC tank circuit exacerbating this oscillation until it reaches its' maximum level. An inverting amplifier can be used similarly; the output is fed to the input; this will cause the output to change as fast as the amplifier can. The frequency of this design is much harder to control, but potentially higher. Also, without the LC tank, the output voltage will remain lower.
even though a resistance is not connected in a circuit, it would practically have small resistance due to its components.so practically a LC circuit dosent exist..only a RLC circuit exists
a "LC circuit at resonance" and tuned circuits are the same
Inside the circuit loop between the inductor and capacitor the current will be at maximum. Outside the circuit the current through the LC tank circuit will be at minimum. It depends on where you are measuring it.
1.CE amplifier circuit 2.LC oscillator circuit
A: actually any active components will oscillate with positive feedback A transistor can be used as an amplifier along with an LC tank circuit to form an oscillator; it is an active device (as LIBURNO states) which will amplify the feedback signal coming out of the LC tank circuit. The tank circuit has a natural resonant frequency, meaning the L and C together will try to generate a specific frequency; this is then fed back into the input of the transistor amplifier, and the output is fed to the LC tank circuit exacerbating this oscillation until it reaches its' maximum level. An inverting amplifier can be used similarly; the output is fed to the input; this will cause the output to change as fast as the amplifier can. The frequency of this design is much harder to control, but potentially higher. Also, without the LC tank, the output voltage will remain lower.
The LC circuit, or tank circuit, is most commonly located in radios. Its function is to tune radio transmitters to a specific station. The LC circuit consists of an inductor (L), and a capacitor(C), hence the term, LC circuit.
A single tuned amplifier basically consists of a tuned circuit (which may consist of an IFT or a parallel tuned LC circuit) connected to the collector of an amplifier circuit (in Common Emitter configuration). The tuned circuit is designed to get a resonant frequency equal to the incoming frequency signal that arrives at the base. The Single Tuned Amplifier gives maximum amplification to that particular incoming frequency which matches the resonant frequency of the tuned circuit and attenuates all other frequencies. Thus it gives sharp selectivity with a high Q-factor.
The equation used to calculate the resonant frequency of an LC circuit is: f 1 / (2(LC)), where f is the resonant frequency, L is the inductance of the circuit, and C is the capacitance of the circuit.
The differential equation governing the behavior of an LC circuit is: d2q/dt2 (1/LC)q 0.
LC means coil capacitance circuit RC means resistance capacitance circuit
The essential components of a feedback LC oscillator include an inductor (L) and a capacitor (C) connected in a feedback loop, a gain element such as a transistor or amplifier to compensate for energy losses, and a feedback network to sustain oscillations by providing positive feedback. The LC tank circuit stores and exchanges energy between the inductor and capacitor to generate an oscillating signal at the resonant frequency of the tank circuit.
even though a resistance is not connected in a circuit, it would practically have small resistance due to its components.so practically a LC circuit dosent exist..only a RLC circuit exists
a "LC circuit at resonance" and tuned circuits are the same
Inside the circuit loop between the inductor and capacitor the current will be at maximum. Outside the circuit the current through the LC tank circuit will be at minimum. It depends on where you are measuring it.
T=sqrtLC