T=sqrtLC
The time constant of an RL series circuit is calculated using the formular: time constant=L/R
LC means coil capacitance circuit RC means resistance capacitance circuit
Answer : increase The time required to charge a capacitor to 63 percent (actually 63.2 percent) of full charge or to discharge it to 37 percent (actually 36.8 percent) of its initial voltage is known as the TIME CONSTANT (TC) of the circuit. Figure 3-11. - RC time constant. The value of the time constant in seconds is equal to the product of the circuit resistance in ohms and the circuit capacitance in farads. The value of one time constant is expressed mathematically as t = RC.
jgfkf
The difference between an RC and LC is that the frequency - determining device in the RC oscillator is not a tank circuit. LC can operate with A or C biasing, while RC can only operate with A.
The LC circuit, or tank circuit, is most commonly located in radios. Its function is to tune radio transmitters to a specific station. The LC circuit consists of an inductor (L), and a capacitor(C), hence the term, LC circuit.
The equation used to calculate the resonant frequency of an LC circuit is: f 1 / (2(LC)), where f is the resonant frequency, L is the inductance of the circuit, and C is the capacitance of the circuit.
The differential equation governing the behavior of an LC circuit is: d2q/dt2 (1/LC)q 0.
The time constant of an RL series circuit is calculated using the formular: time constant=L/R
LC means coil capacitance circuit RC means resistance capacitance circuit
even though a resistance is not connected in a circuit, it would practically have small resistance due to its components.so practically a LC circuit dosent exist..only a RLC circuit exists
a "LC circuit at resonance" and tuned circuits are the same
Inside the circuit loop between the inductor and capacitor the current will be at maximum. Outside the circuit the current through the LC tank circuit will be at minimum. It depends on where you are measuring it.
Self-tuning feedback
A resistor by itself has no time constant. For a circuit to have a time constant it must contain either capacitors or inductors.
When the time constant of an RC circuit increases, the circuit takes longer to reach steady state or fully charge/discharge. This means the circuit responds more slowly to changes in input signals. A larger time constant indicates slower transient response and reduces the frequency at which the circuit can operate effectively.
Answer : increase The time required to charge a capacitor to 63 percent (actually 63.2 percent) of full charge or to discharge it to 37 percent (actually 36.8 percent) of its initial voltage is known as the TIME CONSTANT (TC) of the circuit. Figure 3-11. - RC time constant. The value of the time constant in seconds is equal to the product of the circuit resistance in ohms and the circuit capacitance in farads. The value of one time constant is expressed mathematically as t = RC.