I am in school with maddy R
A suction line filter is added to the system for a different purpose than the liquid line dryer. A suction line filter is added:A : to keep acidic oil in the system from working its way back into the new compressor.B because the suction makes the acid removal better.C because the suction line is cold and full of acid.D all of the above.
I just had change my sand filter and it seem working fine, but it doesn't have enough suction at the skimmers, why it does this?
I am in school with maddy R
A suction machine such as an aspirator can be used to remove mucous and other unwanted fluids.
suction filter
To suction the dirt out of your carpet
An electrostatic filter can be cleaned by using a high power suction device to pull the contaminants from the filter mess itself, for best results apply suction to both sides preferably once a month. If less frequent cleaning or heavy usage of the filter results in a large build up of waste, after the first round of suction, wash the filter in clean warm soapy water and allow to air dry.
The first question to ask is are you getting suction from the pool, When the sand filter is cleaned the pressure goes down. So the only thing you should worry about is. 1 The filter should be set on filter. you should be getting strong suction from the suction side outlet of the pool. and you should make sure you are not sucking air into the skimmer.
When was the last time you cleaned the pool filter?????
The purpose of a filter is to clean out bad particles so that whatever the filter is cleaning will be clean. Save
The purpose of a filter is to clean out bad particles so that whatever the filter is cleaning will be clean. Save
No. It impedes the pressure needed to operate the ram.