If it is a light emitting diode it is there to let you know that the relay is energized.
In my experience, when a DC current is removed from a coil, the polarity of the magnetic field reverses and if it weren't for the diode, the relay would "chatter".
The diode polarity is oppsite of the actuating voltage.
No.
The purpose of the diode is to prevent electricity to flow in the wrong direction in a circuit. The purpose of the diode is to prevent electricity to flow in the wrong direction in a circuit.
general purpose diode with 1000V reverse breakdown.
Quenching diodes are used to protect the control circuit of a relay. Power is applied to a relay's coil to close it. When this power is released there is a backwards flowing pulse that can wipe out solid state devices like transistors, LEDs, chips, etc... The quenching diode is applied in parallel with the relay coil so that the cathode is on the positive side. During normal operation, the diode doesn't conduct and the relay operates normally. When the relay is switched off, the "reversed" back pulse is absorbed due to the low voltage drop of the diode which limits the spike.
it controls the speed. when the diode is busted it gains into fullspeed
No.
If the current through a coil is interrupted, the coil generates a high voltage (such as in the old car ignition coils). The diode provides a path for the current to decay naturally, thus avoiding the high voltage.
ttt
The purpose of the diode is to prevent electricity to flow in the wrong direction in a circuit. The purpose of the diode is to prevent electricity to flow in the wrong direction in a circuit.
The purpose of a diode is to allow electric current to pass in one direction while blocking electric current in the opposite direction. It is for this reason that diode is usually referred as the check valve.
general purpose diode with 1000V reverse breakdown.
Quenching diodes are used to protect the control circuit of a relay. Power is applied to a relay's coil to close it. When this power is released there is a backwards flowing pulse that can wipe out solid state devices like transistors, LEDs, chips, etc... The quenching diode is applied in parallel with the relay coil so that the cathode is on the positive side. During normal operation, the diode doesn't conduct and the relay operates normally. When the relay is switched off, the "reversed" back pulse is absorbed due to the low voltage drop of the diode which limits the spike.
it controls the speed. when the diode is busted it gains into fullspeed
to limit the voltage or regulate the same.
diode is a two terminal passive non linear device.
it has only one diode
The Purpose of a Relay is to control multiple electrical components at once.