0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What should be the setting for a dual voltage selector switch on a power supply when using a computer in the US?
The 110VAC to 125VAC range (not the 220VAC to 250VAC range).
Measure the voltage across a voltmeter and a switch?
If the switch is closed (connected) the voltage across it will read 0V. If the switch is open (disconnected) the voltage across it could be anything, it just depends on what the voltage between the wires going into the switch is.
When measuring voltage drop across a switch what is the maximum allowable voltage drop?
The voltage drop should be as close to zero as would be readable by a typical volt meter. If it is measurable you likely have a problem with corrosion or oxidation in switch that is increasing resistance. If you can measure a voltage drop across a closed switch contact, replace the switch. Or the switch is open, try flipping the switch!
In the unknown of measuring the voltage what should be the setting of VOM selector?
Use the highest available voltage setting. One should know the system voltage before attempting to measure, other wise it may lead to accidents.
In a circuit if the switch is closed how many volts go across the switch?
For an ideal switch, there will be no voltage drop across it. In reality, there will be a very small voltage drop, and this will be dependent on how well made the switch is, and what it is made out of.
Which component probably has a dual-voltage selector switch and has cables that connect to the motherboard and drives?
the hdd
What is the purpose of a transformer?
It steps down voltage by moving the iron core spacing. Mostly using on high current welding transformer. Easy to achieve changing output voltageand does not need to use high power selector to switch voltage
What should be the setting for a dual-voltage selector switch on a power supply when using a computer in the US?
The 110VAC to 125VAC range (not the 220VAC to 250VAC range).
What should be the setting for a dual voltage selector switch on a power supply when using a computer in the US?
The 110VAC to 125VAC range (not the 220VAC to 250VAC range).
What is the switch on a guitar called?
pickup selector switch
How do you read current voltage and resistance with a analog tester?
You just look where the needle is pointing. The trick is to figure out which scale to look at and how much to multiply it by ... but the selector switch is your clue.
How do you replace the fuel selector switch on a 1995 Ford F-250?
how do i replace the fuel selector switch on the dash of a 1995 ford f250
What is Core in a Transformers?
It steps down voltage by moving the iron core spacing. Mostly using on high current welding transformer. Easy to achieve changing output voltageand does not need to use high power selector to switch voltage
Where is the switch that controls the Automatic Transmission?
The selector lever.
When an AC voltage is being measured across a 15 resistor which is carrying a current of 12 amps the selector switch should be set to the AC voltage position of 2 volts 200 volts 20 volts 1000 volts?
Two Hundred
Where is the fuel tank selector switch located on a 1984 F-150?
The fuel tank selector switch can be found on the left side of the dash of a 1984 F-150. This is immediately next to the headlight switch.
What is RF selector switch?
RF refers to 'radio frequency'. A selector switch would select a different range of radio frequencies at each of its positions. RF selector switches would be found on short wave receivers and transmitters.
