answersLogoWhite

0

Full position (up) - 7 ohms

Half tank (middle) - 33 ohms

Empty position (down) - 95 ohms

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the resistance range for a fuel sending unit for a 1967 camaro?

0 Ohms empty, 90 Ohms full.


How many quarts of oil go in a 1989 Ford Festiva?

i have a 91 Festiva, but around that range they are pretty much the same so it is 3 quarts of oil


What ohm range fuel sending unit does a 1997 grand cherokee use?

In the up position, it should be 20 ohms. In the down position, resistance should be 220 ohms.


What do temperature transmitters do?

Avoid sending weak, low-level temperature sensors signals through a noisy plant by converting them to high-level signals that will accurately withstand long-range transmission.


How many ohms is the fuel gauge in a 1958 Buick Roadmaster?

The fuel gauge in a 1958 Buick Roadmaster typically operates with a resistance range of about 0 to 30 ohms when the tank is empty to full. This resistance is part of the variable resistor (or potentiometer) in the sending unit, which translates the fuel level into an electrical signal for the gauge. However, it's always a good idea to consult the specific service manual or documentation for precise specifications.


What resistance is in the center of your ohmmeter scale Rx1 range?

What resistance is the center of your ohm scales, Rx1 range?


What is the maximum speed that can be achieved on a stationary bike?

The maximum speed that can be achieved on a stationary bike depends on the resistance level and the individual's strength and fitness level. Generally, it can range from 20-30 miles per hour.


Which type of resistance training requires muscles to move against resistance through an entire range of motion?

The type of resistance training that involves muscles to move against resistance through an entire range of motion is called Isokinetic exercise. Here's the definition from the Glencoe Health Book: Isokinetic exercise- activity that involves resistance through an entire range of motion. I hope that helped you! :)


Resistance value of good conductor and semiconductors?

Good conductors have low resistance values, typically in the range of single-digit ohms or even less. Semiconductors have higher resistance values compared to conductors, ranging from kiloohms to megaohms, depending on the specific material and doping level.


A DC voltmeter has a resistance of 20000 ohms per volt What is the resistance of the meter if the range selection switch is set on the 250 volt range?

5 megohms


Why there are two possible angles of projection for same range with same velocity of projection?

At a certain angle - 45 degrees if the starting point and end point are at the same level, and air resistance can be ignored - and at a certain speed, the range is maximum. Both for lower and for higher angles, you get a lower range.


How range of a ammeter is extended?

if we take resistance in parallel with ammeter then the range of ammeter will change.