210ft. lbs.
just got my 2004 ram done at the dealer for 83 bucks. worth the money and have them do it :)
30
The General Motors 3.42 rear end pinion?ænut torque specification is 240 pounds. The pinion nut should be torqued in 80 pound intervals.
20 ft lbs
"Snug" will work
I don't believe there is a specific torque specification! Once you install the crush sleeve and tighten the nut to the desired preload on your pinion bearings, your torque will be what it will be.
29-33 ft. lbs.
Preload is the amount the pinion bearings are squeezed together by the pinion nut.
trying to replace rear pinion bearings 1993 ford aerostar, 7.5 rear differential...slinger washer on drive shaft side is stuck, cant get pinion shaft out, all differential parts have been removed...any suggestions?
Rear differential in a rear wheel drive vehicle
Remove driveshaft, remove pinion nut, remove rear cover, remove axles, remove differential. Push pinion out through housing.