0
What is the recommended mileage to replace the timing belt on a 1994 Mercury Tracer?
Wiki User
∙ 18y ago
100,000 miles
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace door speaker in a 1997 murcery tracer?
How to change door speakers on a 1997 mercury tracer wagon
When was Mercury Tracer created?
Mercury Tracer was created in 1987.
How do you replace a head gasket on a 1991 mercury tracer?
Buy the Service Manual and follow the instructions.
How do you replace a Mercury Tracer seat belt?
Seat belts are never repaired, replaced only.
What is the recommended tire pressure for a 1998 Mercury Tracer gs?
the tire pressure should be on a 1998 mercury tracer 32 rear and 32 front also check the passenger front door pillar it will tell you. the pillar is were the door latches to....
How do you replace push rods on 89 Mercury Tracer?
on the 1.6l it does not have pushrods . it has an adjuster on the end of the rocker arm.
How do you find and replace the heater fan resistor on a 1994 Mercury Tracer?
It should be located on the evaporator case.
How to replace Mercury tracer radiator hose?
Drain the Mercury Tracer radiator into a pan. Loosen the clamps at the ends of the radiator hose. Wiggle the hose to free the ends. Slide the hose off and replace it. Tighten the clamps an refill the radiator. Dispose of the old antifreeze as it is toxic to animals.
Timing diagram for a 96 mercury tracer?
need timing marks for 97 mercury tracer
How do you replace the thermostat located on a 1991 Mercury Tracer?
On your 1991 MERCURY TRACER, the THERMOSTAT is: UNDER HOOD, DRIVER SIDE, UPPER ENGINE AREA, ENGINE END OF UPPER RADIATOR HOSE, MOUNTED IN COOLANT OUTLET HOUSING.
When should a 1999 Mercury Tracer timing belt be changed?
On a 1999 Mercury Tracer , 2.0 liter four cylinder engine : According to the 1999 Mercury Tracer maintenance shedule : ( inspect at 120,000 miles ) According to the Gates website : ( inspect at 120,000 miles , replace if required , but I noticed according to the Gates website that it is an INTERFERENCE engine )
How could you replace your stock radio wiring harness in your 1991 Mercury Tracer if you had cut it out?
Tie wraps can be used to replace a stock radio wiring harness in a 1991 Mercury Tracer. The wires can be replaced with other radio wire from an automotive parts store and the tie wrap can hold them together.
