Weddings
Jewelry
Chevy El Camino

What is the ring size and number of splines for a 1982 El Camino 10 bolt?

323334

Top Answer
User Avatar
Wiki User
2007-10-17 06:03:13
2007-10-17 06:03:13

Ring gear size is 8.5 inch , 28 spline axles .

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

what is the bolt pattern for 1985 el camino

User Avatar

If you're referring to the wheel bolt pattern it is 5x4.75

User Avatar

bolt pattern on a 1982 Corolla is 4x4.5

User Avatar

sure, it will bolt right in.

User Avatar

No, this would not be a direct bolt in.

User Avatar

With the serial number that you have provided,your Winchester model 70 bolt action rifle was made in the year 1982.

User Avatar

THM 250/350 accoringing to bolt pattern and Haynes manual

User Avatar

With the serial number that you provided,your Winchester model 70 bolt action rifle was made in the year 1982.

User Avatar

It will not go together, you will not be able to get the retaining plate to match up with the bolt holes until the splines are meshed together.

User Avatar

yes it does the guide says that from 1982-2002 the tire bolt pattern is 5x120

User Avatar

what motor are you running currently is the question and what transmission

User Avatar

It's a measure of the strength of the bolt. The strength is measured using what's called a grade. In this case, you have a grade 8 bolt. The higher the number, the stronger the bolt.

User Avatar

If the number 8999289 is a casting number inside a bell the first number is a 3. Then the block that is in question would be a 4 bolt block with 4 main caps.

User Avatar

What happened was, when the cranks were put on, they were not torqued correctly. After a while the crank arm starts to rock on the spindle causing wear to the splines in the crank arm. Once this wear has taken place, the arm will be almost impossible to keep tight without something like JB Weld or locktite on both the splines of the spindle and the threads of the lock bolt.

User Avatar

it is 5x4 3/4 or 120.6mm same as corvette, firebird, camaro, s-10 p/u and others.

User Avatar

bolt strength markings. Numbers represent metric threads and slashes represent standard threads (the greater the number/slashes, the greater the strength of the bolt.

User Avatar

yes you can, it will bolt right up to your engine, just make sure you have enough tunnel space to fit it.

User Avatar

Take tire off pound out they have splines that press fit and replace, when you bolt tire back on it will seat the new one, make sure it sticks out as far as the rest.

User Avatar

The model is A-Bolt type II or "A Bolt II" It was made in 2000

User Avatar

I have a 1982 Honda Nighthawk. If you remove the bolt in the front of the motor on the bottom the fins and bolt will drop down. You will then see the oil filter cartridge. It looks like an air filter but it is for oil. Change the cartridge and reinstall.

User Avatar

yes, all you need to do is change the motor mounts and put in a bigger radiator.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.