0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the ways to save fuel?
simple with of your engine at the signal
Simple definition of electronic signal?
The simple definition of an electronic signal is a mode of communication that is generated through electric means. This refers to an electric current that is passed in an electromagnetic field.
How can you convert VGA signals to SVGA signals?
yes its very simple to convert VGA signal into SVGA signal.
In amplifier is voltage amplify or only signal of voltage amplify Please give answer in simple englisH IN SIMPLE English an amplifier doesn't need to amplfy any signal to be an amplifier it can be us?
I think Amplifier is use for direct signal or D.C signal & the main function of amplifier is to make that signal sharp(powerful) so that a microprocesser process it.
Why my signal lights are not blinking?
is the car on? do you have the signal on? is there a bulb? are there wires connected to the bulb? or just go to a mech and have him figure it out. simple.
How do you install turn signal switch in 95 Chevy 3500?
It is quite simple to install a new turn signal switch in your 1995 Chevrolet 3500. The turn signal switch simply plugs in and out.
Why small signal equivalent model is needed?
to calculate and measure the impedance ,admittance is simple
Why do we find area of a signal?
hello world
What are three of the most important steps in making a safe right turn?
Mirror,signal, manoeuvre as simple as that.
What is detection of AM?
AM is amplitude modulation. AM detection is the process of demodulation or recovering the information encoded in the signal through amplitude modulation. AM detection can be done through a simple diode detector which rectifies the AM signal.
What is the simple subject of the following sentence Roongthips world is different than mine?
The simple subject of the sentence is "world."
How the envelope detector converts a 455 khz am signal to the message signal?
The diode flips the entire signal to the positive region like a rectifier. Then the parallel rc combination is kept charged or discharged by the carrier frequency, 455kHz. Since the Signal sits on top of the carrier, the output is the original sent signal with some ripple distortion, this can be taken care of with a simple lowpass rc filter
