0
What is the size and thread pitch for a lifting eye for a 150 mercury outboard?
Wiki User
∙ 11y ago
1-1/2x16
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the formula for calculating the pitch of an inch screw thread?
pitch = 1/Threads per Inch So for a 1/2 - 20 thread the pitch is .1
The thread has a pitch of 3 what is the pitch in inches?
A pitch of three means three threads per inch so, one thread every .333 inches.
What is a thread guide?
A thread guide is a tool to measure the number and pitch of threads on a bolt
What cars fit 1.25 thread pitch?
The only cars that I am positive have 1.25 thread pitch is the following; 350z, 370z, G35, G37, and sti's.
What is the best propeller pitch for maximum speed on a 60 horsepower mercury outboard?
Depends on the boat as well. Some boats have different hull designs. So you would need a little more information to answer that question.
What meant by the pitch of a coil?
the pitch of a coil referes to the angle or degree at which the coils slant. in example you will have a different pitch in the thread of metric and imperial screws. also rough and fine thread. hope that helped
What is single thread of screw thread?
when lead of the screw is equal to the pitch it is called single threaded screw
What is the thread pitch for the shift knob on a 2000 Hyundai Elantra GLS?
I believe the thread your looking for is 10x1.25mm
How do you find the pitch of the tap thread?
the pitch is the inverse of the the thread count per inch, or the distance between each thraed pitch = 1/N so for a tap of 32 threads per inch pitch is 1/32 = 0.03125 inch
What is screw thread?
This is a tool that is used to measure the pitch diameter of a screw. This tool looks like a standard micrometer except that the anvils are specially configured to reach into the screw thread groove and touch the pitch diameter of the screw thread. The screw thread micrometer does not measure any other aspect of the screw thread. It does not measure the: pitch; threads-per-inch; major diameter; minor diameter; flank angles; lead; helix angle.
What is the spiral part of a screw called?
Thread
How do you get an outboard to plane out?
set the pitch on the motor there should be a pen that locks it in place
