Sonar uses electricity, so the source of energy is either a generator or a battery.
Sonar wave energy refers to the energy carried by sound waves emitted and detected by sonar systems. These sound waves travel through water, striking objects and bouncing back to the system, providing information about underwater surroundings. Sonar wave energy is essential for navigation, communication, and detection of objects in the ocean.
The two types of sonar are active and passive.Active sonar uses a transmitter, a device that converts electrical energy to sound energy, to send out sound waves. The sound waves travel through the water until they strike an object. The object reflects them in various directions. Some of the reflected waves return to the sonar, where they strike a receiver. Sonar determines distances by measuring the time taken for a sound wave to travel from the transmitter, reflect from the object, and travel to the receiver.Passive sonar receives sound waves given off by some other source, but does not transmit sounds. Passive sonar can therefore determine the direction of an object, but is not as effective as active sonar in determining its distance.Hope I cleared your doubt!- Harman Kahlon
Active sonar sends a signal out from a source and when it encounters an object the signal reflects back to the source. This can be detected by the object it is reflecting off of like a ship or submarine. Passive sonar is simply putting a microphone in the water and listening. It is also undectable.
A pulse of acoustic energy for active sonar is generated by a transducer, which converts electrical energy into sound waves. The transducer emits short bursts of sound, known as sonar pings, into the water. These sound waves travel through the medium and reflect off objects, allowing the sonar system to detect and locate underwater targets based on the time it takes for the echoes to return.
Sonar works by emitting sound waves from a transducer into the water. These sound waves travel through the water until they encounter an object, at which point they bounce back to the sonar device. By measuring the time it takes for the sound waves to return, the sonar device can calculate the distance to the object.
Five uses of sound energy are:HearingTransmission of data (such as fax machines or wireless apps)Sonar used navigation (bats, dolphins, submarines)Sonar used in weather forcastingEntertainment (music, singing)
green energy source
Bats can detect bio-sonar. They use it for echolocation.
The term clean source of energy refers to only primary energy sources as wind or solar energy. Electricity, by definition, is not a primary energy source. It is a secondary energy source that is could be produced by a clean energy source as wind or any renewable primary energy source or produced by fossil energy source as oil, natural gas, or coal.
Side scan sonar uses sonar to map the the ground below by emitting continuous sonar pulses while moving. The sound continuously reflects back to the system's receiver, which creates an image based on the energy of the signal received, where darker points in the image match things protruding from the ground and lighter spots indicate where there is nothing. It does not measure the depth. Side scan sonar is usually towed behind the vessel using it. Multibeam sonar is similar to side scan sonar, except that it is attached to the vessel (rather than being towed) and measures the time difference between sound emission and reception, rather than the energy of the incoming sound waves. Thus, it measures depth instead of making a picture.
waves is not a source of energy
No its not a source of energy..... geez...