0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can graphite stand pressure and temperature of steam?
Up to about 150 psig or so. Yes. Graphite is used for shaft seals on steam powered equipment.
What is the Temp of 30 psi steam?
30 PSIG is about equal to 45 PSIA. Saturation temperature from the steam tables at 45 PSIA is about 274°F. So the steam would be 274°F, or hotter if superheated.
What is the evaporation temperature of R-134a at 0 psig?
-15 degrees
What is the operational temperature and pressure of depropanizer?
the temperature from 260f to 280f under pressure of 320 to 325 psig
What is the evaporation temperature of r410a at 100 psig?
-15 degrees F
How do you convert 15 psia to psig?
psia to psig psig - 15 15 - 15= 0 psig
Boiling point of water under pressure in a outside woodstove?
This is a dangerous practice - make sure you have a safety valve set at a pressure your stove is certified for. The equilibrium steam/water pressure for temperatures above 100 C is: 110 C - 6psig, 120 C - 14 psig, 130 C - 24.5 psig, 140 C - 37.6 psig, 150 C - 54.3 psig.
What is the difference between dry steam and wet steam to clean?
DRY steam is superheated There is a temperature below which steam will start to condense into water droplets. This is called the saturation temperature, and it varies with the pressure of the steam. Steam that is exactly at its saturation temperature is called saturated steam. Steam that is below its saturation temperature contains droplets of moisture and is called wet steam. Steam that is above its saturation temperature is called superheated steam.
What is condensing temperature for a head pressure of 175 psig for an R-12 system?
75 or 80
100 psia to psig?
psia=psig+atmospheric pressure where, atmospheric pressure = 14.7psi therefore psig=psia-atmospheric pressure psig=100-14.7 psig=85.3psig
What is 2 psig mean?
Pounds per Sq in gauge
What is blow down pressure of safety valve?
the blowback or blowdown of the safety valve is at least 2 psi and for pressures over 100 psig is 2% of the popping pressure. The blowback is adjusted with the adjusting ring on the safety valve. The blowback is the pressure less than the popping pressure at which the safety valve will reset. Examples: a safety valve set to pop at 15 psig will reseat at 13 psig, the blowback is 2 psi. A safety valve set to pop at 250 psig will reseat at 245 psig the blowback is 5 psi or 2%.
