0
What is the thickness of countersunk head of 20mm diameter countersunk bolt?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the minimum thickness for a ford escape brake rotor?
Features & Benefits:NAPA Premium Rotors Are Designed To Improve Stopping Distances # of Bolt Holes:5 Bolt Circle Diameter:4.5" Diameter:10.945" Height:1.845" Maximum Lateral Runout:.004" Thickness When New:.945" Discard Thickness:.866" Vented / Solid:Vented Center Hole Diameter:2.84"
What size are a 99 intrepids rear rotors?
diameter: 10.63"thickness when new: .47"discard thickness: .41"height: 1.9"center hole: 2.89"bolt circle: 4.5"
What is the most powerful bolt action rifle?
Anzio Iron Works 20mm
Brake caliper bolt Toyota matrix size?
m8-1.0x 20mm I just replaced mine, it was the top bolt
Bolt size Chevy 350 short water pump?
the bolts are 3/8-16 . as for the length, all that is necessary is about 3/8 of an inch of bolt sticking through the pump, and gasket. a rule of thumb is the length of bolt you need to secure something ,is equal to the diameter of the bolt. that is besides the thickness of what ever you are securing , you should have a bolt at least the diameter of the bolt longer. example- if the pump is 1 inch thick, your bolt should be at least 1 3/8 inch long.
What do you mean by gross diameter of bolt?
This would be concidered the largest diameter,dimension of a bolt.
What does the grade 8.8 bolt identification refer to?
he diameter of the bolt.
Stress on minor diameter of bolt when bolt is subjected to longitudinal force?
The stress on a bolt under longitudinal force is the total force on the bolt divided by the stress area. The stress area is a little bigger than the minor diameter area, calculated from the average of the minor diameter and pitch diameter. The total force on the bolt is its torque preload plus the (bolt stiffness/(bolt +member stiffness) x (externally applied load )
What is the bolt pattern on a 1983 s-10?
1983 Chevrolet S-10 Pickup Bolt Pattern: 5x120.65. Center Bore: 70.3. Hardware:12x1.50 Lug Offset: 00-20mm
How do you measure lug patterns?
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
What does a bolt's wrench diameter mean?
That refers to the size wrench necessary to tighten or loosen the bolt.
What is necked-down bolt?
If a bolt is tightened past a certain point, it deforms by stretching, with the result that its diameter is reduced, if it is tightened past the elastic strain limit of the metal the reduction in diameter is permanent. This can often be seen afterwards in a reduced-diameter 'neck' in the shaft of the bolt where the highest stress occurred.
