tumbler cut
lock and key is the lever of second type
700r4 gear shift lever want lock in place
Hold door handle (opening lever) as if you're opening the door and then push lock lever to lock
It is a Lever handle (long instead of a knob) that has not a lock.
The key lock and the electric motor are two separate items they are conected by a lever. It sounds like the lever is binding sounds like a bad key tumbler
1.sit in car, shut door.Turn on ignition till dash lights come on but don't start engine! 2. Push lever to lock door, pull lever to unlock. Push lever to lock door, pull lever to unlock. Push lever to lock door, pull lever to unlock. 3.Turn off ignition 4. Repeat 2 but with ignition OFF 5. Turn on ignition - should hear a beep 6. Lock door again as in 2 BUT ONLY ONCE - final beep should be heard 7. Done!
I might be able to help but I need to know if it is hammer or hammerless. Also, how does the gun lock up, with a top lever on top or a push-up lever in front of the trigger guard. Also, can you describe the butt plate if it is an original. Ask the question again and put this information in it. lcjones
The slide lock and release lever on the P9 was removed from the P9T.
most land rovers are permenant 4x4 they usually have a second lever to switch between high and low ratio some also have a separate diff lock lever.
If you don't know the code to the combination lock then your stuffed. Just go through all the possible combinations and unlock it (only if its a 3/4 digit) On the other hand if you do know the code and want to change the lock, hold down the unlock button/lever and change the digits and that should change the code.
couple
It also happens to me, and I don't know why?