answersLogoWhite
Timing and Firing Orders
Ford Trucks and SUVs
Chevy Silverado
Ford F-150

What is the timing setting on a 1988 f-150 with a 302 motor?

878889

Top Answer

User Avatar
Wiki User
2005-11-22 14:50:47
2005-11-22 14:50:47

10 degrees BTC(Before Top Dead Center) for both auto and manual trans. Idle 700RPM for manual and 650 RPM for auto trans

1

Related Questions

User Avatar

setting timing on a f150 4.9 6cyl

User Avatar

12 degrees BTDC with the automatic transmission ( unless the engine compartment decal shows different )

User Avatar

how do you adjst clutch on 87ford f150

User Avatar

dose 07 ford 150 have timing belt or timing chanin

User Avatar

Can you put a 350 gm motor in 97 ford f150

User Avatar

www.motorcraft.com shows the ignition timing for a 1986 F150 351 - W code - as 10 degrees BTDC ( information on the underhood sticker overrides ) with automatic transmission ( manual transmission setting is not shown )

User Avatar

The Ford F-150 Lariat has a timing chain, not a timing belt. Unlike a timing belt, there is no need to have the timing chain changed.

User Avatar

www.motorcraft.com shows the ignition timing for a 1979 F150 with the 460 cubic inch ( 7.5 liter ) V8 , automatic transmission , as 14 degrees BTDC

User Avatar

it should be next to the blower motor

User Avatar

how to get the timing gears off the crank and cam shaft

User Avatar

Where is the oil pressure sending unit on a 1995 F150 truck with a 302 motor at

User Avatar

Depending on the motor is it a 108 or a 205

User Avatar

timing should be set at 10 degrees BTDC. be sure you unplug the spout connector before you adjust the timing.

User Avatar

The tension on a 1988 Ford F150 can be loosened by adjusting the belt tensioner. The retaining bolt is loosened, the tensioner shifted slightly, and tightened down.

User Avatar

Most likely and bad blower motor resistor.

User Avatar

On the driver side of the motor. Its about give inches drone the motor mount.

User Avatar

An F150 has to have proper timing or the engine could lose power, or not run at all. Follow the specific procedure for your exact engine to check the timing.

User Avatar

Do we need special tools to install the timing chains on 2003 ford f150 4.6 engine


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.