answersLogoWhite

0


Best Answer

www.motorcraft.com shows the ignition timing for a 1986 F150 351 - W code - as 10 degrees BTDC ( information on the underhood sticker overrides ) with automatic transmission ( manual transmission setting is not shown )

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the timing on a 1986 f-150 351w?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 1978 351w fit in a 1990 f150?

what carbutor model engine fit in a 1994 ford f150 with a 5.8 lighting engine


What transmission will fit a 95 ford f150 351w engine?

a c6 transmission is the best match


Setting timing on a 1995 F150 4.9 6 cylinder.?

setting timing on a f150 4.9 6cyl


What is the timing for 1992 ford Bronco 351w 5.8l?

I believe that is 10 degrees BTDC


How do you tell the difference in the 351w and the 351c?

There are different ways. One is that the 351w fuel pump bolts to the timing cover,the 351c bolts to the engine block. Water flows through the 351w intake manifold and does not on the 351c. The 351w has inline valves and the 351c has canted valves. The 351w has squared intake ports and the 351c has huge round ports. Hope this helps some.


1986 f150 302 emissom light on?

1986 f150 emisson light on is their restn set


Does Ford f150 5.4 v8 have a timing belt or timing chain?

yes its a timing chain


Where would you get the timing procedure for a 351w?

check out these forums, they might help http://ford-trucks.com/forums/


Why is your 69 mustang 351w not starting and back firing?

Sounds like the timing is off or you have a bad distributor.


Does a Ford F150 4.2 V6 have a timing belt or chain?

timing chain


Does a Ford F150 have a timing belt or chain?

dose 07 ford 150 have timing belt or timing chanin


Can you swap the stock I6 with a 351W in a 94 F150?

The answer is yes you can. The bellhousing is the same for the I6, 302, and 351w. You will need the flywheel for the engine you are swaping in. You may also need to change the computer. But if the motor is from around the same year everything should connect just fine.