103 ft/lbs
29 foot pounds
torque wrench settings for the xv,xw,and the xy engine cylinder head bolts are stage 1 50nm or 37 foot pounds stage 2 77nm or 57 foot pounds
63 foot pounds.
46 foot pounds on short bolts 54 foot pounds on long bolts + 90 degees
90 inch - pounds (torque) = 90 / 12 = 7.5 foot pounds (torque)
First start from middle out. 32 foot pounds. then repeat with 64 foot ponds.
You should measure the diameter of the bolts concerned. The information I have applies to the 250 cc as well as the 100 cc versions of this bike. For the 10 mm cylinder head bolts they torque to 27 to 31 foot-pounds. The 6 mm head bolts torque from 7 to10 foot-pounds. The 8mm cylinder cover bolt should torque from 15 to 20 foot-pounds. Hope this helps. .
Spark Plug Gap is .035, Torque then to 20 foot pounds.
Cylinder Head Bolts for 1988-1997 Festiva and Aspire 1.3L I4 Engine Step one: 35-40 foot pounds Step two: 56-60 foot pounds
20nm = 14.751243 foot-pounds.
Its is 20 foot pounds took me all day on my bike to find out what it was
Tighten the drain plug using a two-finger rule till it feels snug(drain plug requires less torque [15 - 25 ft. lbs] than many torque wrenches can be set to, many begin at 25-30ftlbs)so best to NOT use a torque wrenchhowever, if you have a smaller torque wrench , I found this information elsewhere"For the 4.0L six-cylinder, torque the drain plug to 18 foot-pounds of torque. For the 4.6L eight-cylinder, use 19 foot-pounds of torque."