Even without looking up the electrical specifications of the product, we know that
its electrical resistance is relatively low. Any device designed to produce heat must
have a low resistance.
Let's just pull some numbers out of the air:
-- 1500 square feet in the house
-- industry recommends 35 BTU per square foot in your area ==> 52,500 BTU furnace required
-- 3,400 BTU ==> 1 KW; 52,500 BTU ==> 15.4 KW
-- to operate from 240 VAC
Power = E2 / R
15,400 = (240)2 / R
R = (240)2/15,400 = 3.74 ohms
And that's just the heating coils. The big air-mover fans that distribute the
heated air throughout the house are also in parallel, so the load across the
240V service when the furnace is running is less than 3.74 ohms.
We're guessing that electric furnaces don't operate from a normal 120VAC line.
If one did, the corresponding resistance to produce the same amount of heat
would be 0.935 ohm !
The heat produced due to electric current through a resistance is i) directly proportional to the square of the current ii) directly proportional to the resistance value of the conductor iii) directly proportional to the time of flow of current.
What is the electric conductivity value for the glass
yes the R-value does indicate resistance to heat flow
higher
higher
The typical spread (deviation) from the nominal value of the resistance of several resistors.
No, to the flow of electric current.
The resistor a passive component is oppose the flow of electric current. How much it oppose to current it depend on the value of resistance and the value of resistance is mention on it on the color code format. you need to remember the value of every color.
U didn't clearify resistance in what aspect. If u mean electrical resistance,Resistance is phenomenum which describes the limitation of the flow of electric current in an electrical circuit. According to Ohms law (V=IR),the value of resistance is directly proportional to the value of voltage and inversely proportional to the value of current.That is,as the value of resustance increased,voltage also increases;also if the valur of resistance increases,the current reduces(as in I=V/R)
Blast furnace calorific value is 780 Kcal/hr
In the National Electric Code Book or in an Ugly's Electrical Reference book.
how we can calculate the gram chlorific value of an furnace oil pl answer me i will thank full to you
The mean is that value that is most commonly referred to as the average.The typical value is a synonym for the mean and average.The typical value is the mean.
5030
The number of ohms is, precisely, the value of the resistance.
what is the diference betwean calculated and maesured value
sounds like your taking an electricity class. the value of r is resistance. electricity creates heat in what ever it is powering. which in a circuit with out any shorts, grounds or other problems what the electricity is powering is the resistance. so to answer your question temp. changes the value of r