Even without looking up the electrical specifications of the product, we know that
its electrical resistance is relatively low. Any device designed to produce heat must
have a low resistance.
Let's just pull some numbers out of the air:
-- 1500 square feet in the house
-- industry recommends 35 BTU per square foot in your area ==> 52,500 BTU furnace required
-- 3,400 BTU ==> 1 KW; 52,500 BTU ==> 15.4 KW
-- to operate from 240 VAC
Power = E2 / R
15,400 = (240)2 / R
R = (240)2/15,400 = 3.74 ohms
And that's just the heating coils. The big air-mover fans that distribute the
heated air throughout the house are also in parallel, so the load across the
240V service when the furnace is running is less than 3.74 ohms.
We're guessing that electric furnaces don't operate from a normal 120VAC line.
If one did, the corresponding resistance to produce the same amount of heat
would be 0.935 ohm !
A variable resistor is a component that can change its resistance value. By adjusting the resistance, it can control the flow of electric current in a circuit. Increasing the resistance reduces the current flow, while decreasing the resistance increases the current flow. This allows for precise control of the current in a circuit.
No, higher specific resistance means lower conductivity. Specific resistance is the resistance of a material per unit length and cross-sectional area, so a higher value indicates that the material resists the flow of electric current more effectively. Conversely, materials with lower specific resistance values are more conductive.
To find the potential difference across a resistor in an electric circuit, you can use Ohm's Law, which states that voltage (V) equals current (I) multiplied by resistance (R). So, you can calculate the potential difference by multiplying the current flowing through the resistor by the resistance value of the resistor.
The lower the value of the coefficient of friction, the lower the resistance to sliding.
Yes, electric flux can have a negative value if the electric field and the area vector have opposite directions.
The typical spread (deviation) from the nominal value of the resistance of several resistors.
No, to the flow of electric current.
The resistor a passive component is oppose the flow of electric current. How much it oppose to current it depend on the value of resistance and the value of resistance is mention on it on the color code format. you need to remember the value of every color.
Blast furnace calorific value is 780 Kcal/hr
Upgrading to a more energy-efficient electric furnace and AC system for your home can lead to lower energy bills, reduced environmental impact, improved indoor comfort, and potentially increased home value.
U didn't clearify resistance in what aspect. If u mean electrical resistance,Resistance is phenomenum which describes the limitation of the flow of electric current in an electrical circuit. According to Ohms law (V=IR),the value of resistance is directly proportional to the value of voltage and inversely proportional to the value of current.That is,as the value of resustance increased,voltage also increases;also if the valur of resistance increases,the current reduces(as in I=V/R)
A variable resistor is a component that can change its resistance value. By adjusting the resistance, it can control the flow of electric current in a circuit. Increasing the resistance reduces the current flow, while decreasing the resistance increases the current flow. This allows for precise control of the current in a circuit.
how we can calculate the gram chlorific value of an furnace oil pl answer me i will thank full to you
In the National Electric Code Book or in an Ugly's Electrical Reference book.
The mean is that value that is most commonly referred to as the average.The typical value is a synonym for the mean and average.The typical value is the mean.
5030
The electrical resistance of a penny can vary based on its composition and condition, but a typical copper penny (post-1982) has a resistance of about 1 to 2 ohms. This value can change due to factors like oxidation, surface condition, and temperature. Generally, the resistance is low due to copper's excellent conductivity.