Stress has the same dimensions as pressure: force per unit area. In the SI, therefore (or in other MKS systems), the units would be newtons / meter2.
tensile strength is usually given as a stress term - force per unit area. In the English system this is pounds per square inch (psi). In metric SI system,it is given in Meganewtons per meter squared (megapascals, MPa)
stress is load per unit area; when an object is loaded it is under stress and strain and it stretches (strains) until it breaks at its ultimate strength. Stress i srelated to strain in the elastic region by Hooke's law: stress = elastic modulus times strain where modulus is a property of the material and strain is deflection over length
In the foot-lb-sec (FPS) system, an appropriate unit would be cubic feet per second (CFS). A more common unit is gallons per minute (GPM). 1 GPM = .00223 CFS.
Bearing stress is defined as the stress that results from the contact of two members. The equation to determine average bearing stress would be sigmab = P/A where P is the force applied to the member, and A is the contact area of the object resisting the force. The SI unit for bearing stress is Newton/meter2 which equates to Pascals (Pa). The US units for bearing stress are either lb/in2 which equates to pounds per square inch (psi) or kips/in2 Which equals kips per square inch (ksi).
Axial Stress: A tension or compression stress created in a structural member by the application of a lengthwise axial load.Definition Copyright ©1989 CRC Press LLC. All rights reserved.Examples of tensile axial stress include a chain carrying a load and tension cables on a bridge. Examples of compressive axial stress include decorative columns in architecture and the steel structure of a high rise building.Read more: What_is_axial_stressLongitudinal Stress: In continum mechanics, stress is a measure of the average force per unit area of a surface within a deformable body on which internal forces
The correct unit for speed in MKS system is 'm'.
when the unit of any physical quantity is measured in terms of meter or kilogram or second or in combination of these then it is said that unit is in MKS system.
meter/second2.
mks unit for before 10 years old ,now all engineering using only SI unit only
S.i unit
The dioptre, which is equal to 1/meter.
The unit of temperature in MKS (meter-kilogram-second) system is the Kelvin (K).
The centimetre-gram-second system (CGS) is a system of physical units. It is always the same for mechanical units, but there are several variants of electric additions. It was replaced by the MKS, or metre-kilogram-second system, which in turn was replaced by the International System of Units (SI), which has the three base units of MKS plus the ampere, mole, candela and kelvin. from Arun
Any energy - electrical or otherwise - is measured in Joule.
the mks unit is kg/m cube and the cgs unit is g/cm cube
The Joule.
The relevant SI bases are MKS.Length: cgs system uses centimetre, MKS uses metre = 100 centimetres. Mass: cgs system uses grams, MKS uses kilogram = 1000 grams. Time: they both use seconds.