use to?
ebonite rod is a thin, round stick made of hard, black rubber.
When a glass rod is rubbed with rubber, electrons are transferred from the glass to the rubber due to differences in their electronegativities. This leaves the glass rod with a net positive charge, as it has lost electrons.
When a rubber rod is rubbed with wool, electrons are transferred from the wool to the rubber rod. This results in the rubber rod becoming negatively charged and the wool becoming positively charged. This phenomenon is known as triboelectric charging, where rubbing two materials together causes the transfer of electrons between them.
normally, the rubber rod and the peice of fur has an equal number of protons and electrons, making each balanced. When you rub these two together, the rubber rod takes on electrons from the fur, giving the rod more electrons than normal. A negative charge, where as the fur loses electrons creating a positive charge.
When the rubber rod is rubbed with wool, electrons are transferred from the wool to the rubber, leaving the rubber with a net positive charge. This occurs because the rubber has a higher affinity for electrons compared to wool. The excess electrons on the rubber rod result in a net negative charge, as the positive charge was neutralized by the transfer of electrons.
This depends on the type rubber. Example if it is a material used in making water pipe Boil up some water put on end of the rubber ( or plastic in the water it will expand and allow you to put it on the steel rod. If not try greasing the steel rod where you intend to put the rubber on.
tie rod.... your tie rod rubber wore out...needs anew rubber or new tie rod
When a rubber rod is rubbed with wool, electrons are transferred from the wool to the rubber rod, causing the rubber rod to become negatively charged. This transfer of electrons creates an imbalance of charge on the two materials, resulting in the rubber rod being negatively charged.
use the super rod
After removing the flexible rubber cover on the inner tie rod, use a pipe wrench to break the tie rod loose. After a few turns it should be fairly easy to spin it off... Once the old one is off, hand tighten the new one and use a crescent wrench to finish it off.
a knock out rod is the rod that will knockout you when you use it
Hot: cold