0
Is uce to transfer small amounts of liquid to a narrow mouth container
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is use of logic probe in electronic?
we use logic probe in circuit because logic probe is use to indicate where signal is high or low on ic chip.
What is use of probe?
inday
How do you use probe in present tense?
I/you/we/they probe. He/she/it probes. The present participle is probing.
What do you use if you don't have a temperature probe?
you use your finger
How do you use the word probe in a sentence?
One day i would like to probe the bottom of the ocean!
Where can one purchase a current probe?
One can purchase a current probe from the tek website. One can also purchase the current probe from Amazon. One can use the current probe to measure circuit.
How does one use a power probe?
A power probe is used for circuit testing in the automotive industry. Very detailed instructions on how to properly use a power probe can be found on YouTube and through the guidance of trained professionals.
How do you check internal temperature of pot of soup?
You can use an immersion probe to check the internal temperature of a pot of soup. You can also use a thermocouple with a surface probe to check the internal soup temperature.
How can you use space probe in a sentence?
The space probe landed successfully on Mars, where it collected astrological and atmospheric data.
What is the use of Probe laboratory tool?
tool that you use to dissect something with
How do you use a wiggler?
The wiggler body holds the selected probe. Loosen the knurled nut and snap the ball on the end of the probe into the body. Tighten the knurled nut so the probe is not loose, but can still move. When using the dial indicator probe, tighten it firmly. Put the shank of the body into the chuck, end mill holder or collet on your mill or drill press. Use the point probe to find a point on a work piece. This is the probe you use to locate scribed lines on a work piece under the drill or mill chuck. Center the probe by turning on the machine to about 1000 RPM. Use a wooden pencil or other object to press on the side of the probe near the point until it turns true, with no wobble. When you press too hard you will find out why this device is called a wiggler! Once you have the probe centered, turn off the power and center the mark on the work piece under the point of the probe. Use the disk probe to find the edge of a work piece. The disk on the end of this probe is 0.100” in diameter. Center the probe by turning on the machine to about 1000 RPM. Use a wooden pencil or other object to press on the side of the probe near the point until it turns true, with no wobble. Leave the power on as you move the side of the work piece into the tip of the probe. When the probe touches the side of the work piece it will start to wobble. The center of the spindle is 0.050” from the edge of the work. Use the ball probe to find the center of existing holes. Center the probe by turning on the machine to about 1000 RPM. Use a wooden pencil or other object to press on the side of the probe near the point until it turns true, with no wobble. Once you have the probe centered, turn off the power and center the existing hole in the work piece under the ball of the probe. This probe can also be used to find the edge of a work piece. The smaller ball on this probe is 0.250” in diameter, so when it touches the side of the work piece, the center of the spindle is 0.125” from the edge of the work. Use the indicator probe to mount a dial test indicator. Use a dovetail clamp or a body clamp to attach the dial test indicator to the indicator probe. You can use this to check the alignment of a vise on your mill.
What do you use to determine if the reaction is exothermic?
Temperature probe
