Depending on which source you consult, the expected value is betwen 120 and 130 Gpa. On the net it is possible to find the answer in psi (pounds per square inch) but I assume you require a value in SI units. We have just done a classroom experiment which returned a value of about 80 GPa. The stress strain graph looked like a typical ductile material graph, straght line followed by a curve as defopration became plastic. Our value was obtained using the eleastic straight line section. I suspect our low value was due to some 'give' in the anchorage of the specimen wire.
That depends on the temper ( heat treat). For anneled condition (T0) it is 8000 psi and for T6 condition, which is usual specification, it is 35,000 psi. It is in between those values for other tempers between T1 and T5
10.5 million psi at 21 deg C, goes down with temperature. See: http://www.engineeringtoolbox.com/young-modulus-d_773.html
the young's modulus of aluminium is 0.675 * 105
this can also be called as the modulus of elasticity
It depends on the heat treat and type but in general modulus is the same as most all aluminum - around 10.2 million psi or 70.3 GPa
About 65 to 75 GPa
68,600 MPa
7075 is stronger than 6061 aluminum.
That will depend on how it is heat treated and the material type. For example 6061 T6 has an ultimate of 42,000 psi but 6061 annealed is only 18,000 psi. Aluminum 7075 is 80,000 psi heat treated to T6 temper and 33,000 psi annealed.
55
7075 is stronger than 6061 aluminum.
please explain
T6 tells us that how the aluminium was treated.
One cubic inch of 6061 aluminum weighs 0.0975 lb
The aluminum alloy AA 6061 is not soluble in water at room temperature.
Aluminum 6061 T6 has an exact SG of 2.707
potatoe
6061 series
yes it is possible by turning and milling..................
If you are going to eat it I recommend the T6. Otherwise not enough information. A similar question would be. What is better, Grape jam or axle grease?
Al 6061 T6 possesses the similar chemical & mechanical properties as Al 6061 T651. T651 designates that the extrusion has to undergo stretching or permanent set to relieve the extrusion from residual stresses for a uniform machinability. Apart from that, there is no change in the chemical or mechanical properties. Al 6061 T6 is same as Al 6061 T651 & usage of T6 instead of T651 will not affect any functional aspect of the component.