you can not adjust.does it byself
Try this http://tw200forum.com/index.php?/topic/361-adjusting-the-valve-clearance/
spell check your as\nswer
Valve shims are used to compensate for worn valve springs. Your local machine shop will have the tools to check.
The answer is .044
.2mm for intake and .3mm exhaust. or .008in and .012in when the motor is warm. not sure for cold motor.
Yes, it is.
The valves are adjusted by loosening a 10 mm jam nut and checking the clearance with a feeler gauge. A certain procedure must be followed. Just Google "denlors valve adjustment article" for detailed "how to" instructions for most 4cyl Honda engines.
3.6 Quarts (including filter)
This is an interference engine. In most cases the head as well and the pistons will be damaged.
The 1991 Geo Metro EGR valve can be located on the air cleaner housing. The valve will be on the back of the housing.
The 1991 Toyota Corolla does not have a zero-clearance engine. It has a non-interference engine. This means that the pistons will not travel to the pistons.
It's right on the hand side of the motor, under the distributor.
the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.
The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.
Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM for about $9
its on the left hand side of the steering wheel for the turn signal
4 cylinder does not have pcv valve.
on the valve cover
The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.
It is located on the rear left side under the trunk hatch.
Yes it will, have just done the changeover