From one phase to the next you should see 208 Volts.
From any phase to ground you should see 121 Volts.
AnswerYou are very unlikely to come across a two-phase machine, as two-phase a.c. systems are archaic. A two-phase system has two phase voltages that are 90 degrees out of phase with each other, and was used many years' ago. These days, you have either single phase or three phase. So it's probably safe to say that there are no two-phase motors about, these days!
The three phase voltage is 380 the hertz is 50
There is no 'total voltage' in a three-phase system. There are three line voltages and three phase voltages.
One is just as safe as the other. The deciding factor here is what supply voltage do you have at your establishment to operate the welder a single phase or three phase service.
The current is the same in the three live wires. The voltage can be described as the line voltage (phase to neutral) or the phase voltage (phase to phase) which is larger by a factor of sqrt(3). So a line voltage of 230 v corresponds to a phase voltage of 400 v.
The single phase voltage in India is 230v when we check with the phase and the nutral single line
voltage of incoming machine should be same as that of bus bar voltage
Three-phase voltage in Germany is 400V, single-phase voltage is 230V.
The three phase voltage is 380 the hertz is 50
There is no 'total voltage' in a three-phase system. There are three line voltages and three phase voltages.
One is just as safe as the other. The deciding factor here is what supply voltage do you have at your establishment to operate the welder a single phase or three phase service.
The current is the same in the three live wires. The voltage can be described as the line voltage (phase to neutral) or the phase voltage (phase to phase) which is larger by a factor of sqrt(3). So a line voltage of 230 v corresponds to a phase voltage of 400 v.
The formula you are looking for is - phase voltage/1.73 = phase to neutral voltage.
The single phase voltage in India is 230v when we check with the phase and the nutral single line
Let's get the terminology correct. A 'phase voltage' is measured across a phase, whereas a line voltage is measured between two lines. So there is no such thing as a 'phase to phase' voltage -it's a line to line voltage (hence the term 'line voltage').
In three phase: I = (three phase VA) / (sqrt(3) x (phase to phase voltage)) for single phase: I = (single phase VA) / ((phase to neutral voltage)) keep in mine three phase VA = 3 x (single phase VA), and phase to phase voltage = 1.732 x (phase to neutral voltage) Therefore the single phase and three phase currents are the same (ie, the three phase currents are the same in all three phases, or balanced). But don't get available current and available power confused (KVA is not the same as KW).
The voltage in a three phase delta system is stated by the phase to phase voltage. If it is a wye connection the phase to neutral is represented by the two voltages. e.g. 120/208, 240/415, 277/480, 347/600, 7225/12500, etc.
Pakistan has a 220 v 50 Hz domestic supply and the three-phase voltage is sqrt(3) times higher, or 381 v. Higher voltage are also used for three-phase power transmission.