all the sockets are always connected in parallel,due to this the voltage across each soket is same. when any socket is open then there is no voltage loss..so the votage is same like line voltage.
A lamp can be run by power from a telephone line.
The amperage of the circuit increases and the voltage drop across the appliances will tend to increase.
I'd say it wouldn't be -40 volt, but in fact 40 volt. I'm guessing you measured it with a multimeter and had your polarity (positive/negative) mixed up when you placed the leads on the telephone line. -------------------------------------------------------------- The nominal voltage between tip and ring on the telephone line is 48 VDC (it is provided by a 24 cell lead acid battery in the central office) but this can be reduced by line drop by as much as 9 VDC depending on how far you are from the central office. Tip is connected to the positive side of the battery and ring is connected to the negative side of the battery. The tip and ring twisted pair is isolated from ground, so either can be used as your multimeter reference as long as you are aware of polarity so the reading of the multimeter will make sense.
12V. Every resistor in a parallel circuit shares the same voltage. It is the current that gets divided.
The voltage in a socket can be any voltage that you want. The load that connects into the socket must be stated. Without this information the question can not be answered.
AC and telephone should be in separate boxes.
all the sockets are always connected in parallel,due to this the voltage across each soket is same. when any socket is open then there is no voltage loss..so the votage is same like line voltage.
In North America a nominal voltage of 110 to 120 volts comes out of a normal wall socket.
48 VOLTS
1. Unplug from voltage. 2. Remove lamp. 3 Remove socket from stand. 4. Replace old socket with new socket.
48 volts
Only use 110-120 volt appliances on a 110 volt socket.
A lamp can be run by power from a telephone line.
It's the first socket inside your property - that's attached to the line coming in from the telephone pole.
if you have intermittent crackle on telephone. I've been told to replace master telephone socket
A negative live voltage is used to prevent electroytic corrosion on the copper wires.