0
What is the volumein cu ft of a section of drainage pipe that measures 8 feet in length and 24 inches in diameter?
Wiki User
∙ 13y ago
Approx. 25 (8 X PI)
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Calculate the volume in cu. ft. of the section of drainage pipethat measures 8 feet in the length and 24 inches in diameter.?
16cu.ft.
What is the volume in cu ft of a section of drainage pipe that measures 8ft in length and 24 inches in diameter?
Volume of a cylinder = (pi) (radius)2 (length)Volume of the pipe section, with dimensions in feet = (pi) (1)2 (8) = 8 pi = 25.133 cubic ft (rounded)
A log is 2500 cm in lengthhow many meters is itthe diameter cross section measures 250 cm?
The diameter of a log cannot be determined from its length.
Calculate the volume in cu ft of drainage pipe that measures 8 feet in length and 24 inches in diameter?
The volume of a cylinder (the interior volume of the pipe) is calculated by determining the area of the cross-section and multiplying times the length. Cross-section area = pi (r2) = pi (12) square feet = approximately 3.14 square feet Volume of the pipe section = 8 x 3.14 = about 25.1 cubic feet
What does the control measures section covers?
label
What do you call the closing section of a composition?
measures?
What do you call the Closing section of a musical composition?
measures?
If a section of a circle graph measures 180 degrees what percent of a circle graph is this section?
50
Incision and drainage of these glands are not reported using female gential system but instead reported using surgery section urinary system codes?
Incision and drainage of Skene's glands are not reported using Female Genital System, but instead reported using Surgery section, Urinary system codes.
How do you get the radius of a cylinder?
If you have a physical cylinder to measure, measure the "width" of the circle that is the cross section of the cylinder. That is the diameter, Half the diameter is the radius.
Hydraulic diameter of eccentric annulus?
The hydraulic diameter for any cross section is: Dh= 4 * A / Wp Where Dh = hydraulic diameter A = cross sectional area Wp = wetted perimeter
Where can one find information about drainage contractors?
You can find information about drainage contractors through websites such as the small business section found on Yahoo!. If you have a specific business in mind you can also research them using the Better Business Bureau website.
